Hi Troy,
On 13.01.2012 13:10, Dirk Behme wrote:
From: Troy Kisky <troy.ki...@boundarydevices.com>
Previously, only GIGE phy was supported in this function.
Signed-off-by: Troy Kisky <troy.ki...@boundarydevices.com>
CC: Troy Kisky <troy.ki...@boundarydevices.com>
CC: Stefano Babic <sba...@denx.de>
CC: Marek Vasut <marek.va...@gmail.com>
---
common/miiphyutil.c | 18 +++++++++++++++++-
1 files changed, 17 insertions(+), 1 deletions(-)
diff --git a/common/miiphyutil.c b/common/miiphyutil.c
index 2cc23b4..8cb4748 100644
--- a/common/miiphyutil.c
+++ b/common/miiphyutil.c
@@ -471,7 +471,23 @@ int miiphy_speed(const char *devname, unsigned char addr)
(btsr & (PHY_1000BTSR_1000FD | PHY_1000BTSR_1000HD)))
return _1000BASET;
#endif /* CONFIG_PHY_GIGE */
-
+#ifdef CONFIG_PHY_MICREL_KSZ9021
+#define MII_PHY_CTL 0x1f
+#define MII_PHY_CTL_1000 (1 << 6)
+#define MII_PHY_CTL_100 (1 << 5)
+#define MII_PHY_CTL_10 (1 << 4)
+ u16 btsr;
+ if (miiphy_read(devname, addr, MII_PHY_CTL, &btsr)) {
+ printf("PHY 1000BT status");
+ goto miiphy_read_failed;
+ }
+ if (btsr & MII_PHY_CTL_1000)
+ return _1000BASET;
+ if (btsr & MII_PHY_CTL_100)
+ return _100BASET;
+ if (btsr & MII_PHY_CTL_10)
+ return _10BASET;
+#endif
/* Check Basic Management Control Register first. */
if (miiphy_read(devname, addr, MII_BMCR, &bmcr)) {
printf("PHY speed");
Thilo mentioned that on an ARM2 board he additionally needs
diff --git a/common/miiphyutil.c b/common/miiphyutil.c
index 8cb4748..d3ff2af 100644
--- a/common/miiphyutil.c
+++ b/common/miiphyutil.c
@@ -500,6 +500,8 @@ int miiphy_speed(const char *devname, unsigned char
addr)
printf("PHY AN speed");
goto miiphy_read_failed;
}
+ if (anlpar & LPA_1000XFULL )
+ return _1000BASET;
return (anlpar & LPA_100) ? _100BASET : _10BASET;
}
/* Get speed from basic control settings. */
to make GbE work on that board. What do you think?
Best regards
Dirk
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
