On Sat, Jan 14, 2012 at 4:46 PM, Fabio Estevam <feste...@gmail.com> wrote:
> Hi Matthias,
>
> On Sat, Jan 14, 2012 at 10:25 AM, Matthias Fuchs <matthias.fu...@esd.eu>
> wrote:
>> The generic spi flash driver (drivers/mtd/spi/spi_flash.c) uses the
>> spi low level driver's spi_xfer() function with len=0 to deassert the
>> SPI flash' chip select. But the i.MX28 spi driver rejects this call
>> due to len=0.
>>
>> This patch implements an exception for len=0 with the SPI_XFER_END
>> flag set. This results in an extra read with the chip select being
>> deasserted afterwards. There seems to be no way to deassert the signal
>> by hand.
>>
>> Signed-off-by: Matthias Fuchs <matthias.fu...@esd.eu>
>
> What about the approach bellow (untested)?
Actually I meant this:
--- a/drivers/spi/mxs_spi.c
+++ b/drivers/spi/mxs_spi.c
@@ -136,7 +136,7 @@ int spi_xfer(struct spi_slave *slave, unsigned int bitlen,
if (!rx && !tx)
return 0;
- if (flags & SPI_XFER_BEGIN)
+ if ((flags & SPI_XFER_BEGIN) && len)
mxs_spi_start_xfer(ssp_regs);
while (len--) {
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
