Hi Matthias, On Wed, Jan 11, 2012 at 12:41 PM, Matthias Fuchs <matthias.fu...@esd.eu> wrote: > Hi Fabio, > > can you confirm that the current u-boot-imx tree runs fine > on the MX28EVK? I tried it but the debug console stays dead.
Yes, it works fine. > This is what I did: > > 1) make mx28evk I think you meant "mx28evk_config" > 2) make u-boot.sb > 3) ./tools/mxsboot sd u-boot.sb u-boot-sd.sb > 4) prepare an SD card as described in doc/README.m28 (only one partition > of type 53) > 5) dd u-boot-sd.sb to above partition > 6) install SD and press power button On my board I don't have to press the power button in order to get the console output. Please check your MX28EVK settings: - Boot Mode Select: 1 0 0 1 - JTAG PSWITCH RESET: To the left (reset enabled) - Battery Source: Down - Wall 5V: Up - VDD 5V: To the left (off) - Hold Button: Down (off) Also, I have only tested this on a MX28EVK rev.D board. > > BTW: Did you ever try Freescales sd_loader to download u-boot > into RAM? > > FYI: There also seems to be a Linux version of the USB loader > (http://svn.rockbox.org/viewvc.cgi/trunk/utils/imxtools/). I haven't tried this yet. Regards, Fabio Estevam _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
