Am Donnerstag, den 05.01.2012, 20:19 +0100 schrieb Wolfgang Denk: > Dear Stephan Linz, > > In message <1325783490.7827.45.camel@keto> you wrote: > > > > Michals latest Microblaze platform patches will enable this driver for > > board/xilinx/microblaze-generic and we know about a success story on a > > propietary Virtex5 FX board (ppc440) -- tested by Ricardo Ribalda. > > > > -- snip -- > So I'll rework the driver and > > present a new v8 patch as soon as possible. > > OK. Please submit it only if it comes with code that references the > driver.
Hi Wolfgang, I understand your opinions to stick together all the different code fragments. Unfortunately, this driver will be used by systems with synthesized hardware (FPGA SoftCPU systems). The target board (hardware around the FPGA) will be fixed but the content (CPU, controller, busses, interfacess, addresses, ...) will be variable and not fixed. That's why we use a so named microblaze-generic board configuration controlled by the header xparameters.h in board directory. The default content of xparameters.h is really only basic and enables not nearly half of all possibilities. For example the default configuration in xparameters.h will enable the Xilinx EMAC-Lite driver (with XILINX_EMACLITE_BASEADDR) but do nothing to enable the Xilinx AXI-EMAC driver (with XILINX_AXIEMAC_BASEADDR) -- it makes no sense to enable both at the same time. I'll provide the same way for the Xilinx LL_TEMAC driver as for the Xilinx AXI-EMAC driver. I prepare the microblaze-generic board code to support all potential Ethernet drivers but leave out the specific usage. You are right when you say that there is no code that refere to the new driver code -- there are also no configuration for this. And yes we adapt/change the xparameters.h out of mainline tree to enable the driver code -- but I think, that is not really a "out of tree port". But what would be the best implementation for unspecified targets here? @Michal: Is there anybody who use the current default configuration from microblaze-generic/xparameters.h on a real FPGA system design? If not we could expand xparameters.h with a fantasy configuration to enable all potential drivers used on a Microblaze system. So we have a reference to driver code and can test the rebuild again and again with a simple 'make microblaze-generic'. What do you mean? -- Best regards, Stephan Linz ______________________________________________________________________________ MB-Ref: http://www.li-pro.de/xilinx_mb:mbref:start OpenDCC: http://www.li-pro.net/opendcc.phtml PC/M: http://www.li-pro.net/pcm.phtml Sourceforge: http://sourceforge.net/users/slz Gitorious: https://gitorious.org/~slz _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
