2012/1/2 Thierry Reding <thierry.red...@avionic-design.de>: > This card-detect hook probably doesn't work. Perhaps somebody with more > knowledge about the hardware can comment on this. I think that perhaps > even the complete code from esdhc_init() could go into the getcd() > function instead or mmc_getcd() needs to be called at some later time > after mmc_init(), which, however, would require many other drivers to > change.
yes, the hook in the patch does not work for the fsl i.mx sdhc controller due to silicon issues and we need always use gpio to read the card detection status. > > In addition to implementing the hook, this patch also removes the call > to the board_mmc_getcd() function which is now called from the MMC > framework and is no longer required here. > > Signed-off-by: Thierry Reding <thierry.red...@avionic-design.de> > --- Tested ok on i.mx51evk board, Tested-by: Jason Liu <jason....@linaro.org> > drivers/mmc/fsl_esdhc.c | 29 ++++++++++++----------------- > 1 files changed, 12 insertions(+), 17 deletions(-) > > diff --git a/drivers/mmc/fsl_esdhc.c b/drivers/mmc/fsl_esdhc.c > index f038acc..1ed5355 100644 > --- a/drivers/mmc/fsl_esdhc.c > +++ b/drivers/mmc/fsl_esdhc.c > @@ -418,7 +418,6 @@ static int esdhc_init(struct mmc *mmc) > struct fsl_esdhc_cfg *cfg = (struct fsl_esdhc_cfg *)mmc->priv; > struct fsl_esdhc *regs = (struct fsl_esdhc *)cfg->esdhc_base; > int timeout = 1000; > - int ret = 0; > > /* Reset the entire host controller */ > esdhc_write32(®s->sysctl, SYSCTL_RSTA); > @@ -445,24 +444,19 @@ static int esdhc_init(struct mmc *mmc) > /* Set timout to the maximum value */ > esdhc_clrsetbits32(®s->sysctl, SYSCTL_TIMEOUT_MASK, 14 << 16); > > - /* Check if there is a callback for detecting the card */ > - ret = board_mmc_getcd(mmc); > - if (ret < 0) { > - timeout = 1000; > - while (!(esdhc_read32(®s->prsstat) & PRSSTAT_CINS) && > - --timeout) > - udelay(1000); > + return 0; > +} > > - if (timeout <= 0) > - ret = NO_CARD_ERR; > - } else { > - if (ret == 0) > - ret = NO_CARD_ERR; > - else > - ret = 0; > - } > +static int esdhc_getcd(struct mmc *mmc) > +{ > + struct fsl_esdhc_cfg *cfg = (struct fsl_esdhc_cfg *)mmc->priv; > + struct fsl_esdhc *regs = (struct fsl_esdhc *)cfg->esdhc_base; > + int timeout = 1000; > + > + while (!(esdhc_read32(®s->prsstat) & PRSSTAT_CINS) && --timeout) > + udelay(1000); > > - return ret; > + return timeout > 0; > } > > static void esdhc_reset(struct fsl_esdhc *regs) > @@ -500,6 +494,7 @@ int fsl_esdhc_initialize(bd_t *bis, struct fsl_esdhc_cfg > *cfg) > mmc->send_cmd = esdhc_send_cmd; > mmc->set_ios = esdhc_set_ios; > mmc->init = esdhc_init; > + mmc->getcd = esdhc_getcd; > > voltage_caps = 0; > caps = regs->hostcapblt; > -- > 1.7.8.1 > > _______________________________________________ > U-Boot mailing list > U-Boot@lists.denx.de > http://lists.denx.de/mailman/listinfo/u-boot _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot