On 11/15/2011 04:51 PM, Fabio Estevam wrote:
> Configure the pins as GPIO prior to using gpio_get_value.
>
> Signed-off-by: Fabio Estevam<fabio.este...@freescale.com>
> ---
> board/freescale/mx53ard/mx53ard.c | 3 +++
> 1 files changed, 3 insertions(+), 0 deletions(-)
>
> diff --git a/board/freescale/mx53ard/mx53ard.c
> b/board/freescale/mx53ard/mx53ard.c
> index be32aee..e5a1142 100644
> --- a/board/freescale/mx53ard/mx53ard.c
> +++ b/board/freescale/mx53ard/mx53ard.c
> @@ -87,6 +87,9 @@ int board_mmc_getcd(u8 *cd, struct mmc *mmc)
> {
> struct fsl_esdhc_cfg *cfg = (struct fsl_esdhc_cfg *)mmc->priv;
>
> + mxc_request_iomux(MX53_PIN_GPIO_1, IOMUX_CONFIG_ALT1);
> + mxc_request_iomux(MX53_PIN_GPIO_4, IOMUX_CONFIG_ALT1);
> +
> if (cfg->esdhc_base == MMC_SDHC1_BASE_ADDR)
> *cd = gpio_get_value(1); /*GPIO1_1*/
> else
Applied to u-boot-imx, thanks
Best regards,
Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
