Hello Heiko, On Wed, Nov 9, 2011 at 1:18 PM, Heiko Schocher <h...@denx.de> wrote: > Christian Riesch wrote: >> 332 lpsc_on(DAVINCI_LPSC_UART2); >> 333 NS16550_init((NS16550_t)(CONFIG_SYS_NS16550_COM1), >> 334 CONFIG_SYS_NS16550_CLK / 16 / CONFIG_BAUDRATE); >> 335 >> 336 /* >> 337 * Fix Power and Emulation Management Register >> 338 * see sprufw3a.pdf page 37 Table 24 >> 339 */ >> 340 writel(readl((CONFIG_SYS_NS16550_COM1 + 0x30)) | 0x00006001, >> 341 (CONFIG_SYS_NS16550_COM1 + 0x30)); >> >> I guess this is only needed for debugging the SPL? > > This must be done before using the uart as a console, and I think > this should be done in common code as early as possible.
Yes, but it will also be done later in serial_init() called from board_init_f(), right? So this is only a hack to allow debug messages at this stage before it is done properly in serial_init(). Am I missing something here? Regards, Christian _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
