always do the cpu critical inits in cpu_init_crit,
and only jump to lowlevel_init, if CONFIG_SKIP_LOWLEVEL_INIT
is not defined.
Signed-off-by: Heiko Schocher <h...@denx.de>
Cc: Albert ARIBAUD <albert.u.b...@aribaud.net>
Cc: Wolfgang Denk <h...@denx.de>
Cc: Sandeep Paulraj <s-paul...@ti.com>
Cc: Tom Rini <tom.r...@gmail.com>
Cc: Christian Riesch <christian.rie...@omicron.at>
---
arch/arm/cpu/arm926ejs/start.S | 6 ++----
1 files changed, 2 insertions(+), 4 deletions(-)
diff --git a/arch/arm/cpu/arm926ejs/start.S b/arch/arm/cpu/arm926ejs/start.S
index 339c5ed..8b5355b 100644
--- a/arch/arm/cpu/arm926ejs/start.S
+++ b/arch/arm/cpu/arm926ejs/start.S
@@ -194,9 +194,7 @@ reset:
* we do sys-critical inits only at reboot,
* not when booting from ram!
*/
-#ifndef CONFIG_SKIP_LOWLEVEL_INIT
bl cpu_init_crit
-#endif
/* Set stackpointer in internal RAM to call board_init_f */
call_board_init_f:
@@ -353,7 +351,6 @@ _dynsym_start_ofs:
*
*************************************************************************
*/
-#ifndef CONFIG_SKIP_LOWLEVEL_INIT
cpu_init_crit:
/*
* flush v4 I/D caches
@@ -372,14 +369,15 @@ cpu_init_crit:
orr r0, r0, #0x00001000 /* set bit 12 (I) I-Cache */
mcr p15, 0, r0, c1, c0, 0
+#ifndef CONFIG_SKIP_LOWLEVEL_INIT
/*
* Go setup Memory and board specific bits prior to relocation.
*/
mov ip, lr /* perserve link reg across call */
bl lowlevel_init /* go setup pll,mux,memory */
mov lr, ip /* restore link */
- mov pc, lr /* back to my caller */
#endif /* CONFIG_SKIP_LOWLEVEL_INIT */
+ mov pc, lr /* back to my caller */
#ifndef CONFIG_SPL_BUILD
/*
--
1.7.6.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
