> On 10/26/2011 10:25 AM, Stefano Babic wrote: > > On 10/25/2011 05:25 PM, Marek Vasut wrote: > >> The problem was caused by a global variable being used early in the boot > >> process. > >> > >> The symptoms were on imx31_phycore board, reading the environment from > >> I2C EEPROM didn't work correctly and causes default environment to be > >> loaded. > >> > >> Signed-off-by: Marek Vasut <marek.va...@gmail.com> > >> Cc: Wolfgang Denk <w...@denx.de> > >> Cc: Albert ARIBAUD <albert.u.b...@aribaud.net> > >> Cc: Heiko Schocher <h...@denx.de> > >> Cc: Stefano Babic <sba...@denx.de> > >> Tested-by: Anatolij Gustschin <ag...@denx.de> > >> --- > >> > >> drivers/i2c/mxc_i2c.c | 29 ++++++++++++++++------------- > >> 1 files changed, 16 insertions(+), 13 deletions(-) > >> > >> V2: Fix commit message > > > > Tested on mx35pdk. > > > > Tested-by: Stefano Babic <sba...@denx.de> > > I tested (and it works), but there is a problem. I supposed it was a > mistake by me, but after some checks I have found the cause. > > Your patch does not apply on current u-boot-imx. You sent earlier the > patch: > > "I2C: Add i2c_get/set_speed() to mxc_i2c.c" > > that after Heiko's ACK I have applied to u-boot-imx and then it is > already merged into u-boot-arm. The patch you have sent now does not > take care of your previous patch and does not apply anymore. > > Can you rebase your patch ? You can take u-boot-imx als reference, all > imx related patches are already applied. > > Best regards, > Stefano Babic
Hi Stefano, done rebasing on u-boot-imx/master and tested on imx31_phycore. Cheers _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
