> -----Original Message-----
> From: Premi, Sanjeev 
> Sent: Friday, September 02, 2011 9:27 PM
> To: u-boot@lists.denx.de
> Cc: Premi, Sanjeev
> Subject: [PATCH v2] omap3evm: Set environment variable 'ethaddr'
> 
> It is now responsibility of the board specific init
> code to set the environment variable corresponding
> to the MAC address.
> 
> Signed-off-by: Sanjeev Premi <pr...@ti.com>
> ---
> 
>    Changes in v2:
>    - Ensure that environment variable is set iff
>      it wasn't already set earlier.
> 
>   Tested on omap3evm at against latest master at:
>   bd061a5 : Merge branch 'master' of git://git.denx.de/u-boot-sh
> 
>   To build successfully, make this substituion in board/ti/evm/evm.c:
>   -#include <asm/arch/gpio.h>
>   +#include <asm/omap_gpio.h>
>   This problem was addressed in separate RFC. Patches
>   will follow shortly. (Substituion is not real fix).

Sandeep,

Wanted to check the status of this patch.
I believe I have addressed all concerns in v2.

Also, with generic gpio patches merged in, the "substitution" mentioned
above is not necessary.

I just validated this patch on ti/master. It applies cleanly and works
fine.

~sanjeev

> 
>  board/ti/evm/evm.c |   15 +++++++++++++++
>  1 files changed, 15 insertions(+), 0 deletions(-)
> 
> diff --git a/board/ti/evm/evm.c b/board/ti/evm/evm.c
> index 30c1c57..ae3f713 100644
> --- a/board/ti/evm/evm.c
> +++ b/board/ti/evm/evm.c
> @@ -216,7 +216,22 @@ int board_eth_init(bd_t *bis)
>  {
>       int rc = 0;
>  #ifdef CONFIG_SMC911X
> +#define STR_ENV_ETHADDR      "ethaddr"
> +
> +     struct eth_device *dev;
> +     uchar eth_addr[6];
> +
>       rc = smc911x_initialize(0, CONFIG_SMC911X_BASE);
> +
> +     if (!eth_getenv_enetaddr(STR_ENV_ETHADDR, eth_addr)) {
> +             dev = eth_get_dev_by_index(0);
> +             if (dev) {
> +                     eth_setenv_enetaddr(STR_ENV_ETHADDR, 
> dev->enetaddr);
> +             } else {
> +                     printf("omap3evm: Couldn't get eth device\n");
> +                     rc = -1;
> +             }
> +     }
>  #endif
>       return rc;
>  }
> -- 
> 1.7.0.4
> 
> 
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to