Dear Sven, Am 12.10.2011 16:51, schrieb Sven Schnelle: > On 10/12/2011 04:29 PM, Andreas Bießmann wrote: >> Dear Sven, >> >> Am 12.10.2011 15:09, schrieb Sven Schnelle:
<snip> >> And does not work on device: >> >> a) mmc init is not known? Is this not longer necessar > 'mmc init' is only available if CONFIG_GENERIC_MMC isn't set, at least > that's how i unterstand the source code. (See common/cmd_mmc.c:29) I see, my fault. Didn't know about this new framework. >> b) ext2ls is not reliable: >> >> ---8<--- >> U-Boot> ext2ls mmc 0:1 >> <DIR> 1024 . >> <DIR> 1024 .. >> <DIR> 12288 lost+found >> gen_atmel_mci: CMDR 00051051 (17) ARGR 02008600 (SR: 00400025) Data >> Transfer Failed >> ** ext2fs_devread read error - last part >> U-Boot> >> --->8--- > Hmm, that's really bad. What type of card is this? MMC, SD or SDHC? It is SD card (the one delivered with my atstk1002, there is an Atmel label on it ;). When initialising mmc with old atmel_mci driver I get this: ---8<--- U-Boot> mmc init Manufacturer ID: 03 OEM/Application ID: 5344 Product name: SD128 Product Revision: 5.8 Product Serial Number: 8227719 Manufacturing Date: 06/03 SD Card detected (RCA 58916) CSD data: 00260032 1f5983c0 fefa4fff 924040ab CSD structure version: 1.0 MMC System Spec version: 0 Card command classes: 1f5 Read block length: 512 Supports partial reads Write block length: 512 Does not support partial writes Supports group WP: 32 Card capacity: 125960192 bytes File format: 0/0 Write protection: mmc: Using 131072 cycles data timeout (DTOR=0x62) .mmc1 is available --->8--- best regards Andreas Bießmann _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
