On Thursday, September 15, 2011 10:21:04 PM stefano babic wrote: > Am 15/09/2011 21:39, schrieb Fabio Estevam: > > Hi, > > Hi Fabio, > > > When using U-boot from top of tree I am not able to get networking to > > work on a mx31pdk: > > > > uboot> dhcp > > smc911x: detected LAN9217 controller > > smc911x: phy initialized > > smc911x: MAC 00:04:9f:00:8d:6e > > BOOTP broadcast 1 > > BOOTP broadcast 2 > > DHCP client bound to address 10.29.244.21 > > BOOTP broadcast 3 > > DHCP client bound to address 10.29.244.21 > > BOOTP broadcast 4 > > DHCP client bound to address 10.29.244.21 > > BOOTP broadcast 5 > > DHCP client bound to address 10.29.244.21 > > > > Retry count exceeded; starting again > > I see... > > > I haven't started debugging this, but would like to check first if > > this is a known issue. > > I have not heard about this issue. > > > Running v2011.06 makes networking to work fine. > > > > I have not enabled the caches on this board yet and I do see a warning > > in boot saying > > that caches are not enabled. > > I know the commit, the same warning appears on a lot of other boards. It > is only a remind that cache is not enabled because the drivers do not > work if cache is enabled (as th FEC driver, for example).
I'm working on the FEC patch that allows it to work with caches actually. I have it ready, but it needs some polishing. > > > Does anyone have smc911x working with the latest U-boot? > > I have now tested on a mx35pdk with Debug board. It has a SMC911x. It > works: > > U-Boot 2011.09-rc1-00020-g56fa45d (Sep 15 2011 - 22:08:55) > > CPU: Freescale i.MX35 at 532 MHz > Board: MX35 PDK 2.0 i.MX35 2.0 [WDT] > I2C: ready > DRAM: 256 MiB > WARNING: Caches not enabled > Flash: 64 MiB > NAND: 2048 MiB > In: serial > Out: serial > Err: serial > Net: smc911x-0, FECWarning: failed to set MAC address > > Hit any key to stop autoboot: 0 > MX35 U-Boot > > > MX35 U-Boot > run load > smc911x: detected LAN9217 controller > smc911x: phy initialized > smc911x: MAC 00:04:9f:00:f4:99 > Using smc911x-0 device > TFTP from server 192.168.2.14; our IP address is 192.168.2.97 > Filename 'mx35pdk/u-boot.bin'. > Load address: 0x80800000 > Loading: ################# > done > Bytes transferred = 248892 (3cc3c hex) > > Best regards, > Stefano Babic _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
