On 09/14/2011 12:26 AM, Fabio Estevam wrote: > commit e5226e63 (Makefile: remove tx25 exception) missed to pass NAND_U_BOOT > option when moving tx25 target to boards.cfg. > > Signed-off-by: Fabio Estevam <fabio.este...@freescale.com> > --- > boards.cfg | 2 +- > 1 files changed, 1 insertions(+), 1 deletions(-) >
Hi Fabio, > diff --git a/boards.cfg b/boards.cfg > index 1e2ff43..58f677f 100644 > --- a/boards.cfg > +++ b/boards.cfg > @@ -148,7 +148,7 @@ sheevaplug arm arm926ejs - > Marvell > dockstar arm arm926ejs - > Seagate kirkwood > jadecpu arm arm926ejs jadecpu > syteco mb86r0x > mx25pdk arm arm926ejs mx25pdk > freescale mx25 > mx25pdk:IMX_CONFIG=board/freescale/mx25pdk/imximage.cfg > -tx25 arm arm926ejs tx25 > karo mx25 > +tx25 arm arm926ejs tx25 > karo mx25 tx25:NAND_U_BOOT > zmx25 arm arm926ejs zmx25 > syteco mx25 > imx27lite arm arm926ejs imx27lite > logicpd mx27 > magnesium arm arm926ejs imx27lite > logicpd mx27 I was too fast...I reread the whole thread (http://patchwork.ozlabs.org/patch/112080/) CONFIG_NAND_U_BOOT is defined in tx25.h, and there is no need to define it again. I think the actual patch is ok. Have you seen any problem ? Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
