Dear Michal Simek, In message <[email protected]> you wrote: > > >> +/* Axi Ethernet registers offset */ > >> +#define XAE_IS_OFFSET 0x0000000C /* Interrupt status */ > >> +#define XAE_IE_OFFSET 0x00000014 /* Interrupt enable */ > >> +#define XAE_RCW1_OFFSET 0x00000404 /* Rx Configuration Word 1 */ > >> +#define XAE_TC_OFFSET 0x00000408 /* Tx Configuration */ > >> +#define XAE_EMMC_OFFSET 0x00000410 /* EMAC mode configuration */ > >> +#define XAE_MDIO_MC_OFFSET 0x00000500 /* MII Management Config */ > >> +#define XAE_MDIO_MCR_OFFSET 0x00000504 /* MII Management Control */ > >> +#define XAE_MDIO_MWD_OFFSET 0x00000508 /* MII Management Write Data > >> */ > >> +#define XAE_MDIO_MRD_OFFSET 0x0000050C /* MII Management Read Data > >> */ > > > > Please use struct xae_regs {...} as the rest of the u-boot. > > struct is not useful here because it will be big with a lot of reserved > values.
Code based on base address + offset notation will not be accepted. Please do use a struct as requested. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [email protected] If programming was easy, they wouldn't need something as complicated as a human being to do it, now would they? - L. Wall & R. L. Schwartz, _Programming Perl_ _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
