Dear Andreas,
On 08/26/2011 12:45 PM, Andreas Bießmann wrote:
> Dear Simon
>
> Am 26.08.2011 12:17, schrieb Simon Schwarz:
>> On 08/25/2011 01:28 PM, Andreas Bießmann wrote:
>>> Dear Simon,
>
> <snip>
>
>>>> +/* This function jumps to an image with argument. Normally an FDT or
>>>> ATAGS
>>>> + * image.
>>>> + * arg: Pointer to paramter image in RAM
>>>> + */
>>>> +void jump_to_image_linux(void *arg)
>>>> +{
>>>> + debug("Entering kernel arg pointer: 0x%X\n", arg);
>>>> + typedef void (*image_entry_arg_t)(int, int, void *)
>>>> + __attribute__ ((noreturn));
>>>> + image_entry_arg_t image_entry =
>>>> + (image_entry_arg_t) spl_image.entry_point;
>>>> + /* cleanup_before_linux(); */ /*write SPL function for that*/
>>>> + image_entry(0, CONFIG_SYS_SPL_MACHID, arg);
>>>
>>> the MACHID is saved in gd->bd, couldn't this be used here?
>>> BTW: You missed setting CONFIG_SYS_SPL_MACHID in your board
>>> configuration header in this patch. Where is it done?
>>>
>>
>> In SPL gd is not fully initialized.
>
> I see ... but how about using existing CONFIG_MACH_TYPE then?
>
done.
>> CONFIG_SYS_SPL_MACHID is set see below in include/configs/devkit8000.h
>
> Sorry for the noise, did not see it.
>
> regards
>
> Andreas Bießmann
>
regards
Simon
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
