Enable high-speed MMC modes. Signed-off-by: Eric Chung <[email protected]>
--- v2: - Enable ADMA support. - Enable SYSCON support. --- board/spacemit/k1/MAINTAINERS | 1 + configs/spacemit_k1_defconfig | 19 +++++++++++++++++++ 2 files changed, 20 insertions(+) diff --git a/board/spacemit/k1/MAINTAINERS b/board/spacemit/k1/MAINTAINERS index 32d47ecc8f1..ca994e2a1fb 100644 --- a/board/spacemit/k1/MAINTAINERS +++ b/board/spacemit/k1/MAINTAINERS @@ -9,6 +9,7 @@ F: configs/spacemit_k1_defconfig F: doc/board/spacemit/bananapi-f3.rst F: drivers/gpio/spacemit_gpio.c F: drivers/i2c/k1_i2c.c +F: drivers/mmc/spacemit_sdhci.c F: drivers/pinctrl/spacemit/ F: drivers/power/pmic/pmic_spacemit_p1.c F: drivers/power/regulator/spacemit_p1_regulator.c diff --git a/configs/spacemit_k1_defconfig b/configs/spacemit_k1_defconfig index 81409c844a6..886679367a9 100644 --- a/configs/spacemit_k1_defconfig +++ b/configs/spacemit_k1_defconfig @@ -23,6 +23,7 @@ CONFIG_DEBUG_UART_BASE=0xd4017000 CONFIG_DEBUG_UART_CLOCK=14700000 CONFIG_TARGET_SPACEMIT_K1=y CONFIG_ARCH_RV64I=y +CONFIG_RISCV_ISA_ZICBOM=y CONFIG_RISCV_SMODE=y CONFIG_SPL_RISCV_MMODE=y # CONFIG_SPL_SMP is not set @@ -48,6 +49,7 @@ CONFIG_SPL_CMD_TLV_EEPROM=y CONFIG_OF_UPSTREAM=y CONFIG_ENV_OVERWRITE=y CONFIG_SPL_REGMAP=y +CONFIG_SYSCON=y CONFIG_SPL_SYSCON=y CONFIG_CLK=y CONFIG_CLK_CCF=y @@ -87,6 +89,21 @@ CONFIG_SPI_FLASH_WINBOND=y CONFIG_SPI_MEM=y CONFIG_SYS_SPI_U_BOOT_OFFS=0x000a0000 CONFIG_CMD_SPI=y +CONFIG_MMC=y +CONFIG_MMC_SDHCI=y +CONFIG_MMC_SDHCI_ADMA=y +CONFIG_MMC_SDHCI_SPACEMIT=y +CONFIG_MMC_IO_VOLTAGE=y +CONFIG_MMC_HS200_SUPPORT=y +CONFIG_MMC_HS400_SUPPORT=y +CONFIG_MMC_HS400_ES_SUPPORT=y +CONFIG_SUPPORT_EMMC_BOOT=y +CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION=y +CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION=0x4 +CONFIG_CMD_MMC=y +CONFIG_CMD_MEMINFO=y +CONFIG_CMD_MEMINFO_MAP=y +CONFIG_EFI_PARTITION=y CONFIG_SPL_SPI=y CONFIG_SPL_DM_SPI=y CONFIG_SPL_DM_SPI_FLASH=y @@ -94,3 +111,5 @@ CONFIG_SPL_SPI_LOAD=y CONFIG_SPL_SPI_FLASH_TINY=y CONFIG_SPL_SPI_FLASH_SUPPORT=y CONFIG_SPL_BOARD_INIT=y +CONFIG_SPL_MMC=y +CONFIG_SPL_SYS_MMCSD_RAW_MODE=y -- 2.51.0
