Hi Tom, On Mon, 10 Nov 2025 at 08:42, Tom Rini <[email protected]> wrote: > > This is the Gitlab side of adding support for the board lab connected to > the "konsulko-sage" runner. On the software side, this lab uses only > upstream labgrid. On the hardware side, each device under test is > connected to its own exporter (typically a Raspberry Pi 4) that must be > turned on (and cleanly turned off) as part of a given test cycle. > > Add support for testing on a SolidRun Hummingboard 2 (imx6), Raspberry > Pi 3 and Raspberry Pi 4. In all cases, we enable additional options to > run more tests on the board. As we have some networking tests, we test > both the legacy network stack and lwIP. In the case of Pi platforms, we > test all of 32bit configuration, plain configuration and rpi_arm64, and > again with and without lwIP. > > Signed-off-by: Tom Rini <[email protected]> > --- > Note that for the Pi platforms we enable/disable CMD_BOOTEFI_SELFTEST > based on overall binary size. I've created > https://source.denx.de/u-boot/custodians/u-boot-raspberrypi/-/issues/2 > to track addressing that issue. > --- > .gitlab-ci-sage-lab.yml | 182 ++++++++++++++++++++++++++++++++++++++++ > .gitlab-ci.yml | 5 ++ > 2 files changed, 187 insertions(+) > create mode 100644 .gitlab-ci-sage-lab.yml
Would it be possible to add some docs about this? Does the exporting rpi do a full system boot and then run some scripts to load things onto the board, then shut down? Regards, Simon
