Avoid use of hard-coded address in boot command, instead use $loadaddr
which is the default load address. This improves consistency of the
environment on this board.
Signed-off-by: Marek Vasut <marek.vasut+rene...@mailbox.org>
---
Cc: Nobuhiro Iwamatsu <iwama...@nigauri.org>
Cc: Paul Barker <paul.barker...@bp.renesas.com>
Cc: Tom Rini <tr...@konsulko.com>
Cc: u-boot@lists.denx.de
---
configs/r8a779g3_sparrowhawk_defconfig | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/configs/r8a779g3_sparrowhawk_defconfig
b/configs/r8a779g3_sparrowhawk_defconfig
index 9cee4d287ef..2d1abf6f26d 100644
--- a/configs/r8a779g3_sparrowhawk_defconfig
+++ b/configs/r8a779g3_sparrowhawk_defconfig
@@ -18,7 +18,7 @@ CONFIG_SYS_BARGSIZE=2048
CONFIG_SYS_CBSIZE=2048
CONFIG_BAUDRATE=921600
CONFIG_BINMAN=y
-CONFIG_BOOTCOMMAND="tftp 0x50000000 fitImage && bootm 0x50000000"
+CONFIG_BOOTCOMMAND="tftp ${loadaddr} fitImage && bootm ${loadaddr}"
CONFIG_DEFAULT_FDT_FILE="r8a779g3-sparrow-hawk.dtb"
CONFIG_CMD_REMOTEPROC=y
CONFIG_GPIO_HOG=y
--
2.50.1
