From: Frieder Schrempf <frieder.schre...@kontron.de>
In case of the i.MX8M power-domains (i.MX8MQ, MM, MN) there is only
one power-domain for each device. Therefore the 'id' field in struct
power_domain should always be zero.
Currently if a power-domain is accessed after the initial bind, the
'id' field is left uninitialized. This didn't cause any problems
until the following commits were introduced:
9086b64ca071 ("power-domain: Add support for refcounting (again)")
a785ef24487b ("imx: power-domain: Enable refcounting on imx8mp")
Now the 'id' field gets accessed in the power_domain_off() sequence
and the invalid value causes "Synchronous Abort" failures.
This was observed on a i.MX8MM board when running "usb start" and
then "usb stop".
Fix this issue by setting power_domain->id to '0' in
imx8m_power_domain_of_xlate().
Signed-off-by: Frieder Schrempf <frieder.schre...@kontron.de>
Fixes: d08a194871fd ("imx: add support for i.MX8MQ power domain controller")
Fixes: 9086b64ca071 ("power-domain: Add support for refcounting (again)")
---
drivers/power/domain/imx8m-power-domain.c | 2 ++
1 file changed, 2 insertions(+)
diff --git a/drivers/power/domain/imx8m-power-domain.c
b/drivers/power/domain/imx8m-power-domain.c
index b44aae78e6d..a7e64971a2a 100644
--- a/drivers/power/domain/imx8m-power-domain.c
+++ b/drivers/power/domain/imx8m-power-domain.c
@@ -468,6 +468,8 @@ out_clk_disable:
static int imx8m_power_domain_of_xlate(struct power_domain *power_domain,
struct ofnode_phandle_args *args)
{
+ power_domain->id = 0;
+
return 0;
}
--
2.50.1
