> -----Original Message----- > From: Holger Brunck [mailto:holger.bru...@keymile.com] > Sent: Wednesday, June 08, 2011 5:13 PM > To: u-boot@lists.denx.de > Cc: Valentin Longchamp; Holger Brunck; Prafulla Wadaskar; Heiko Schocher > Subject: [PATCH v2 5/5] arm/km: add support for portl2 board > > From: Valentin Longchamp <valentin.longch...@keymile.com> > > This adds support for the keymile Kirkwood BEC portl2 board. This board > relies on the km_arm (km_kirkwood) BEC. > > The egiga driver is configured for a 100M full-duplex, A/N off > connnection > to the backplane. This board has always ethernet present, because it is > connected to the marvell switch similar to mgcoge3un. The reset_phy > functionality is also the same to mgcoge3un. > > Signed-off-by: Valentin Longchamp <valentin.longch...@keymile.com> > Signed-off-by: Holger Brunck <holger.bru...@keymile.com> > cc: Prafulla Wadaskar <prafu...@marvell.com> > cc: Heiko Schocher <h...@denx.de> > --- > Changes for v2: > - add this board support patch to the end of the serie > > MAINTAINERS | 1 + > MAKEALL | 1 + > board/keymile/km_arm/km_arm.c | 8 +++-- > boards.cfg | 1 + > include/configs/portl2.h | 81 > +++++++++++++++++++++++++++++++++++++++++ > 5 files changed, 89 insertions(+), 3 deletions(-) > create mode 100644 include/configs/portl2.h >
Applied to u-boot-marvell.git next branch Regards.. Prafulla . . _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
