Add SPL specific DT additions to DH STM32MP13xx DHCOR DHSBC . These
include I2C3 configuration which is required to access the PMIC,
PMIC regulator and QSPI NOR bootph-all properties to allow SPL to
configure PMIC buck regulators and load from QSPI NOR respectively,
etzpc bus switch to simple-bus to prevent interference from TFABOOT
specific configuration, and RCC configuration to define clock tree
configuration used by this platform.
Signed-off-by: Marek Vasut <marek.va...@mailbox.org>
---
Cc: Cheick Traore <cheick.tra...@foss.st.com>
Cc: Fabrice Gasnier <fabrice.gasn...@foss.st.com>
Cc: Gatien Chevallier <gatien.chevall...@foss.st.com>
Cc: Lionel Debieve <lionel.debi...@foss.st.com>
Cc: Pascal Zimmermann <pzimmerm...@dh-electronics.com>
Cc: Patrice Chotard <patrice.chot...@foss.st.com>
Cc: Patrick Delaunay <patrick.delau...@foss.st.com>
Cc: Simon Glass <s...@chromium.org>
Cc: Sughosh Ganu <sughosh.g...@linaro.org>
Cc: Tom Rini <tr...@konsulko.com>
Cc: u-b...@dh-electronics.com
Cc: u-boot@lists.denx.de
Cc: uboot-st...@st-md-mailman.stormreply.com
---
arch/arm/dts/stm32mp13xx-dhcor-u-boot.dtsi | 155 ++++++++++++++++++++-
1 file changed, 154 insertions(+), 1 deletion(-)
diff --git a/arch/arm/dts/stm32mp13xx-dhcor-u-boot.dtsi
b/arch/arm/dts/stm32mp13xx-dhcor-u-boot.dtsi
index 6117da10bbf..b5952637442 100644
--- a/arch/arm/dts/stm32mp13xx-dhcor-u-boot.dtsi
+++ b/arch/arm/dts/stm32mp13xx-dhcor-u-boot.dtsi
@@ -3,6 +3,7 @@
* Copyright (C) 2024 Marek Vasut <ma...@denx.de>
*/
+#include <dt-bindings/clock/stm32mp13-clksrc.h>
#include "stm32mp13-u-boot.dtsi"
#include "stm32mp13-ddr3-dhsom-1x2Gb-1066-binG.dtsi"
@@ -19,8 +20,12 @@
};
};
+&etzpc {
+ compatible = "simple-bus";
+};
+
&flash0 {
- bootph-pre-ram;
+ bootph-all;
partitions {
compatible = "fixed-partitions";
@@ -49,6 +54,134 @@
};
};
+&i2c3 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&i2c3_pins_a>;
+};
+
+&qspi {
+ bootph-all;
+};
+
+&qspi_clk_pins_a {
+ bootph-all;
+ pins {
+ bootph-all;
+ };
+};
+
+&qspi_bk1_pins_a {
+ bootph-all;
+ pins {
+ bootph-all;
+ };
+};
+
+&qspi_cs1_pins_a {
+ bootph-all;
+ pins {
+ bootph-all;
+ };
+};
+
+&pinctrl {
+ bootph-all;
+ i2c3_pins_a: i2c3-0 {
+ bootph-all;
+ pins {
+ bootph-all;
+ pinmux = <STM32_PINMUX('B', 8, AF5)>, /* I2C3_SCL */
+ <STM32_PINMUX('H', 14, AF4)>; /* I2C3_SDA */
+ bias-disable;
+ drive-open-drain;
+ slew-rate = <0>;
+ };
+ };
+};
+
+&rcc {
+ clocks = <&clk_hse>, <&clk_hsi>, <&clk_csi>, <&clk_lse>, <&clk_lsi>;
+
+ st,clksrc = <
+ CLK_MPU_PLL1P
+ CLK_AXI_PLL2P
+ CLK_MLAHBS_PLL3
+ CLK_PLL12_HSE
+ CLK_PLL3_HSE
+ CLK_PLL4_HSE
+ CLK_CKPER_HSE
+ CLK_RTC_LSE
+ CLK_MCO1_LSI
+ CLK_MCO2_HSI
+ >;
+
+ st,clkdiv = <
+ 0 /*AXI*/
+ 0 /*MLHAB*/
+ 1 /*APB1*/
+ 1 /*APB2*/
+ 1 /*APB3*/
+ 1 /*APB4*/
+ 2 /*APB5*/
+ 1 /*APB6*/
+ 0 /*RTC*/
+ >;
+
+ st,pkcs = <
+ CLK_I2C12_HSI
+ CLK_I2C3_HSI
+ CLK_QSPI_PLL3R
+ CLK_SAES_AXI
+ CLK_SDMMC1_PLL3R
+ CLK_SDMMC2_PLL3R
+ CLK_STGEN_HSE
+ CLK_UART2_HSI
+ CLK_UART4_HSI
+ CLK_USBO_USBPHY
+ CLK_USBPHY_HSE
+ >;
+
+ /*
+ * cfg = < DIVM1 DIVN P Q R PQR(p,q,r) >;
+ * frac = < f >;
+ *
+ * PRQ(p,q,r) ... for p,q,r: 0-output disabled / 1-output enabled
+ * DIVN ... actually multiplier, but RCC_PLL1CFGR1 calls the field DIVN
+ * m ... for PLL1,2: m=2 ; for PLL3,4: m=1
+ * XTAL = 24 MHz
+ *
+ * VCO = ( XTAL / (DIVM1 + 1) ) * m * ( DIVN + 1 + ( f / 8192 ) )
+ * P = VCO / (P + 1)
+ * Q = VCO / (Q + 1)
+ * R = VCO / (R + 1)
+ */
+
+ /* VCO = 1066.0 MHz => P = 266 (AXI), Q = 266, R = 533 (DDR) */
+ pll2: st,pll@1 {
+ compatible = "st,stm32mp1-pll";
+ reg = <1>;
+ cfg = < 2 65 1 1 0 PQR(1,1,1) >;
+ frac = < 0x1400 >;
+ bootph-all;
+ };
+
+ /* VCO = 600 MHz => P = 200, Q = 150, R = 200 */
+ pll3: st,pll@2 {
+ compatible = "st,stm32mp1-pll";
+ reg = <2>;
+ cfg = < 2 74 2 3 2 PQR(1,1,1) >;
+ bootph-all;
+ };
+
+ /* VCO = 750.0 MHz => P = 125, Q = 83, R = 75 */
+ pll4: st,pll@3 {
+ compatible = "st,stm32mp1-pll";
+ reg = <3>;
+ cfg = < 3 124 5 8 9 PQR(1,1,1) >;
+ bootph-all;
+ };
+};
+
&sdmmc1 {
status = "disabled";
};
@@ -56,3 +189,23 @@
&usbotg_hs {
u-boot,force-b-session-valid;
};
+
+&vddcpu {
+ bootph-all;
+};
+
+&vdd_ddr {
+ bootph-all;
+};
+
+&vdd {
+ bootph-all;
+};
+
+&vddcore {
+ bootph-all;
+};
+
+&vref_ddr {
+ bootph-all;
+};
--
2.47.2
