[PATCH] spi: fsl_qspi: Move AHB read buffer config after LUT

[Pawel Kochanowski]

When using CONFIG_FSL_QSPI_AHB_FULL_MAP the fsl_qspi_default_setup() sets
the BFGENCR register to use the LUT(SEQID_LUT_AHB) before the Look Up Table
is populated.

This result in a situation that after 'sf probe' command any memory
read from qspi using AHB will result in undefined behaviour (hang) untill
first 'sf read' op is executed.

Move the BFGENCR write to fsl_qspi_prepare_lut() to ensure that the setup
is consistent. AHB reads will use the default LUT(index 0) setup by previous
boot stage untill the first read op.

Signed-off-by: Pawel Kochanowski <pkochanow...@sii.pl>
---
 drivers/spi/fsl_qspi.c | 13 ++++++-------
 1 file changed, 6 insertions(+), 7 deletions(-)

diff --git a/drivers/spi/fsl_qspi.c b/drivers/spi/fsl_qspi.c
index c7f554826c3..65ab3e306d7 100644
--- a/drivers/spi/fsl_qspi.c
+++ b/drivers/spi/fsl_qspi.c
@@ -472,7 +472,13 @@ static void fsl_qspi_prepare_lut(struct fsl_qspi *q,
                    op->addr.nbytes) {
                        for (i = 0; i < ARRAY_SIZE(lutval); i++)
                                qspi_writel(q, lutval[i], base + 
QUADSPI_AHB_LUT_REG(i));
+
+                       qspi_writel(q, QUADSPI_BFGENCR_SEQID(SEQID_LUT_AHB),
+                               q->iobase + QUADSPI_BFGENCR);
                }
+       } else {
+               qspi_writel(q, QUADSPI_BFGENCR_SEQID(SEQID_LUT),
+                       q->iobase + QUADSPI_BFGENCR);
        }
 
        /* lock LUT */
@@ -737,13 +743,6 @@ static int fsl_qspi_default_setup(struct fsl_qspi *q)
        qspi_writel(q, 0, base + QUADSPI_BUF1IND);
        qspi_writel(q, 0, base + QUADSPI_BUF2IND);
 
-       if (IS_ENABLED(CONFIG_FSL_QSPI_AHB_FULL_MAP))
-               qspi_writel(q, QUADSPI_BFGENCR_SEQID(SEQID_LUT_AHB),
-                           q->iobase + QUADSPI_BFGENCR);
-       else
-               qspi_writel(q, QUADSPI_BFGENCR_SEQID(SEQID_LUT),
-                           q->iobase + QUADSPI_BFGENCR);
-
        qspi_writel(q, QUADSPI_RBCT_WMRK_MASK, base + QUADSPI_RBCT);
        qspi_writel(q, QUADSPI_BUF3CR_ALLMST_MASK |
                    QUADSPI_BUF3CR_ADATSZ(q->devtype_data->ahb_buf_size / 8),
-- 
2.43.0