Tom sorry about sending this reply twice, struggle here is with
Thunderbird mail UI sometimes hiding "Reply All" and it missed the mail
list first time around.
On 1/2/25 14:47, Tom Rini wrote:
On Thu, Jan 02, 2025 at 02:26:06PM -0800, E Shattow wrote:
Problem: 'dhcp' must be ran twice when the network cable is plugged into a
port other than the first network port.
Network cable plugged into bottom (first) Ethernet port:
1. Power on
2. StarFive # dhcp
ethernet@16030000 Waiting for PHY auto negotiation to complete....... done
DHCP client bound to address 192.168.2.51 (3678 ms)
Network cable plugged into top (second) Ethernet port:
1. Power on
2. StarFive # dhcp
ethernet@16030000 Waiting for PHY auto negotiation to complete.........
TIMEOUT !
phy_startup() failed: -110
FAILED: -110
ethernet@16040000 Waiting for PHY auto negotiation to complete...... done
ethernet@16030000 Waiting for PHY auto negotiation to complete.........
TIMEOUT !
phy_startup() failed: -110
FAILED: -110
Could not start ethernet@16030000
3. StarFive # dhcp
DHCP client bound to address 192.168.2.77 (31 ms)
What happens when you set ethact to 1 first?
'1' literal does not seem to do something so I guess it is meant the id
of the first ethernet interface:
From power-on:
...
starfive_7110_pcie pcie@2b000000: Starfive PCIe bus probed.
starfive_7110_pcie pcie@2c000000: Starfive PCIe bus probed.
In: serial@10000000
Out: serial@10000000
Err: serial@10000000
Net: eth0: ethernet@16030000, eth1: ethernet@16040000
starting USB...
No USB controllers found
Working FDT set to ff700a10
StarFive # env print ethact
## Error: "ethact" not defined
StarFive # env set ethact 1
StarFive # dhcp
ethernet@16030000 Waiting for PHY auto negotiation to complete.........
TIMEOUT !
phy_startup() failed: -110
FAILED: -110
ethernet@16040000 Waiting for PHY auto negotiation to complete...... done
EQOS_DMA_MODE_SWR stuck
FAILED: -110
Could not start ethernet@16030000
Again, from power-on:
starfive_7110_pcie pcie@2b000000: Starfive PCIe bus probed.
starfive_7110_pcie pcie@2c000000: Starfive PCIe bus probed.
In: serial@10000000
Out: serial@10000000
Err: serial@10000000
Net: eth0: ethernet@16030000, eth1: ethernet@16040000
starting USB...
No USB controllers found
Working FDT set to ff700a10
StarFive # env print ethact
## Error: "ethact" not defined
StarFive # env set ethact ethernet@16040000
StarFive # dhcp
ethernet@16040000 Waiting for PHY auto negotiation to complete...... done
DHCP client bound to address 192.168.2.77 (149 ms)
-E
