Hello Lothar, Am Wed, Dec 04, 2024 at 06:33:13PM +0000 schrieb Lothar Rubusch: > Fix some typos and duplicate words in gdb.rst. > > Signed-off-by: Lothar Rubusch <l.rubu...@gmail.com> > Acked-by: Alexander Dahl <a...@thorsis.com> > --- > doc/develop/gdb.rst | 10 +++++----- > 1 file changed, 5 insertions(+), 5 deletions(-) > > diff --git a/doc/develop/gdb.rst b/doc/develop/gdb.rst > index 4e359c7f22..79510ee94d 100644 > --- a/doc/develop/gdb.rst > +++ b/doc/develop/gdb.rst > @@ -8,12 +8,12 @@ Using a JTAG adapter it is possible to debug a running > U-Boot with GDB. > A common way is to connect a debug adapter to the JTAG connector of your > board, run a GDB server, connect GDB to the GDB server, and use GDB as usual. > > -Similarly QEMU can provide a GDB server. > +Similarly, QEMU can provide a GDB server. > > Preparing build > --------------- > > -Building U-Boot with with reduced optimization (-Og) and without link time > +Building U-Boot with reduced optimization (-Og) and without link time > optimization is recommended for easier debugging:: > > CONFIG_CC_OPTIMIZE_FOR_DEBUG=y > @@ -24,7 +24,7 @@ Otherwise build, install, and run U-Boot as usual. > Using OpenOCD as GDB server > --------------------------- > > -`OpenOCD <https://openocd.org/>`_ is an open source tool supporting hardware > +`OpenOCD <https://openocd.org/>`_ is an open-source tool supporting hardware > debug probes, and providing a GDB server. It is readily available in major > Linux > distributions or you can build it from source. > > @@ -144,7 +144,7 @@ riscv gp > sh r13 > ============ ======== > > -On these architecture the relocation address cat be determined by > +On these architectures the relocation address can be determined by > dereferencing the global data pointer stored in register, *r9* in the > example: > > .. code-block:: console > @@ -153,7 +153,7 @@ dereferencing the global data pointer stored in register, > *r9* in the example: > $1 = 0x27f7a000 > > In the GDB shell discard the previously loaded symbol file and add it once > -again with the relocation address like this: > +again, with the relocation address like this:
Acked-by: Alexander Dahl <a...@thorsis.com> Greets Alex