On 2024/11/6 05:51, Jonas Karlman wrote:
For some reason the Ethernet PHY reset delay is set to 1 second, this cause an unneccecery long boot delay. MiQi use RTL8211 Ethernet PHY, datasheet list an initial 10ms delay and then a 30-76ms delay before accessing registers. Change to use 80ms delay instead of a full second to speed up Ethernet initializion in U-Boot. Also enable PHY_REALTEK, DM_ETH_PHY and PHY_GIGE to improve Ethernet PHY support in U-Boot. Signed-off-by: Jonas Karlman <jo...@kwiboo.se>
Reviewed-by: Kever Yang <kever.y...@rock-chips.com> Thanks, - Kever
--- arch/arm/dts/rk3288-miqi-u-boot.dtsi | 4 ++++ configs/miqi-rk3288_defconfig | 3 +++ 2 files changed, 7 insertions(+) diff --git a/arch/arm/dts/rk3288-miqi-u-boot.dtsi b/arch/arm/dts/rk3288-miqi-u-boot.dtsi index 4361b35d6c8f..e5c7e761c46f 100644 --- a/arch/arm/dts/rk3288-miqi-u-boot.dtsi +++ b/arch/arm/dts/rk3288-miqi-u-boot.dtsi @@ -41,6 +41,10 @@ bootph-some-ram; };+&gmac {+ snps,reset-delays-us = <0 10000 80000>; +}; + &gpio7 { /delete-property/ bootph-all; bootph-pre-ram; diff --git a/configs/miqi-rk3288_defconfig b/configs/miqi-rk3288_defconfig index ee9917149734..55e8d30f675f 100644 --- a/configs/miqi-rk3288_defconfig +++ b/configs/miqi-rk3288_defconfig @@ -55,6 +55,9 @@ CONFIG_MISC=y CONFIG_ROCKCHIP_EFUSE=y CONFIG_MMC_DW=y CONFIG_MMC_DW_ROCKCHIP=y +CONFIG_PHY_REALTEK=y +CONFIG_DM_ETH_PHY=y +CONFIG_PHY_GIGE=y CONFIG_ETH_DESIGNWARE=y CONFIG_GMAC_ROCKCHIP=y CONFIG_PINCTRL=y
