Hi,
I'm working on a custom board based on P1011.
There are 2 board flavours, with either 128MB or 256MB of soldered
DDR2 SDRAM. Having u-boot image per board works fine, but I'd like
to have a single image and use get_ram_size() to detect memory size
at runtime. So far I had no luck.
The only significant difference between memory devices on these boards
is the number of banks: 4 banks on 128MB board and 8 banks on 256MB
board.
The memory size detection logic is loosely based on the code in
boards/tqc/tqm85xx/sdram.c, but I use fsl_ddr_set_memctl_regs()
to configure DDR controller registers and enable the controller.
The sequence is:
1. Configure TLBs for 2GB DDR
2. Configure LAWs for 2GB DDR
3. Configure DDR controller registers and enable DDR controller,
CS0_BNDS is set to 256MB.
4. Iterate over possible memory sizes starting from the largest.
Each iteration configures CS0_CONFIG (sets number of banks, rows
and columns)
and runs get_ram_size()
What I observe on 128MB board, is that only 32KB of RAM is detected in
both
first and second iteration. So it seems that setting number of banks
to 8 on
4-bank devices is fatal, and cannot be changed even if CS0_CONFIG is
modified.
I've tried to rerun DDR controller initialization sequence with new
CS0_CONFIG
value, but that just hangs the board. I've also tried to disable DDR
controller via
RORDEVDISR register and then enable it and reconfigure DDR. That also
leads
to hang.
I hope Freescale gurus on the list can help me to find a solution.
Thanks in advance.
Felix.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
