In some cases (consistently in my case with an embedded board) the
ethernet controller will time out on the first init but always succeed
after reset.
Let's reset the controller during probe so we always start with it in a
known state, and don't have wait for the first asix_wait_link() to
time out.
Signed-off-by: Caleb Connolly <caleb.conno...@linaro.org>
---
I see this behaviour consistently across three Qualcomm platforms that use this
controller.
---
drivers/usb/eth/asix88179.c | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/drivers/usb/eth/asix88179.c b/drivers/usb/eth/asix88179.c
index 7bfd285b3aa4..a0aa5c25e428 100644
--- a/drivers/usb/eth/asix88179.c
+++ b/drivers/usb/eth/asix88179.c
@@ -628,8 +628,14 @@ static int ax88179_eth_probe(struct udevice *dev)
usb_dev = priv->ueth.pusb_dev;
priv->maxpacketsize = usb_dev->epmaxpacketout[AX_ENDPOINT_OUT];
+ ret = asix_basic_reset(&priv->ueth, priv);
+ if (ret) {
+ printf("Failed to reset ethernet device\n");
+ return ret;
+ }
+
/* Get the MAC address */
ret = asix_read_mac(&priv->ueth, pdata->enetaddr);
if (ret)
return ret;
--
2.45.0
