> -----Original Message----- > From: Clint Adams [mailto:cl...@debian.org] > Sent: Wednesday, April 13, 2011 12:14 AM > To: u-boot@lists.denx.de > Cc: Prafulla Wadaskar; julian.pidan...@citrix.com; Clint Adams > Subject: [PATCH 2/3] Initialize second PHY on OpenRD-Client and OpenRD- > Ultimate. > > (rework of Julian Pidancet's patch) > --- > board/Marvell/openrd_base/openrd_base.c | 24 ++++++++++++++++++++---- > include/configs/openrd_base.h | 14 ++++++++++++-- > 2 files changed, 32 insertions(+), 6 deletions(-) > > diff --git a/board/Marvell/openrd_base/openrd_base.c > b/board/Marvell/openrd_base/openrd_base.c > index f7c63ac..cb0f0fe 100644 > --- a/board/Marvell/openrd_base/openrd_base.c > +++ b/board/Marvell/openrd_base/openrd_base.c > @@ -124,12 +124,11 @@ int board_init(void) > } > > #ifdef CONFIG_RESET_PHY_R > -/* Configure and enable MV88E1116 PHY */ > -void reset_phy(void) > +/* Configure and enable MV88E1116/88E1121 PHY */ > +void mv_phy_init(char *name) > { > u16 reg; > u16 devadr; > - char *name = "egiga0"; > > if (miiphy_set_current_dev(name)) > return; > @@ -154,6 +153,23 @@ void reset_phy(void) > /* reset the phy */ > miiphy_reset(name, devadr); > > - printf("88E1116 Initialized on %s\n", name); > + printf(PHY_NO" Initialized on %s\n", name); > +} > + > +void reset_phy(void) > +{ > + mv_phy_init("egiga0"); > + > +#ifdef CONFIG_BOARD_IS_OPENRD_CLIENT > + /* Kirkwood ethernet driver is written with the assumption that > in case > + * of multiple PHYs, their addresses are consecutive. But > unfortunately > + * in case of OpenRD-Client, PHY addresses are not > consecutive.*/ > + miiphy_write("egiga1", 0xEE, 0xEE, 24); > +#endif > + > +#if defined(CONFIG_BOARD_IS_OPENRD_CLIENT) || > defined(CONFIG_BOARD_IS_OPENRD_ULTIMATE)
The line is too long >80 chars Regards.. Prafulla . . _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
