On Sat, Feb 17, 2024 at 12:08:40PM +0000, Jonas Karlman wrote:
> Pinconfig nodes normally bind recursively with PINCTRL_FULL and
> PINCONF_RECURSIVE enabled. However, during U-Boot proper pre-relocation
> any node marked with e.g. bootph-all will not bind unless its parent is
> also marked for pre-reloc.
>
> group1 {
> pinconf1 {
> bootph-all;
> };
> };
>
> This cause the following warning message to be shown during U-Boot
> proper pre-reloc stage on Rockchip devices, e.g on RK3568:
>
> ns16550_serial serial@fe660000: pinctrl_select_state_full:
> uclass_get_device_by_phandle_id: err=-19
>
> and on RK3328:
>
> ns16550_serial serial@ff130000: pinctrl_select_state_full:
> uclass_get_device_by_phandle_id: err=-19
>
> Check pinconfig nodes pre-reloc status recursively to fix this and to
> make pinconfig_post_bind work same at both U-Boot proper pre-reloc and
> at TPL/SPL stage.
>
> Signed-off-by: Jonas Karlman <jo...@kwiboo.se>Applied to u-boot/next, thanks! -- Tom
signature.asc
Description: PGP signature
