The polling rate is already specified in some devicetrees, like
imx8mp.dtsi for example, but was not selected so far. For the
trippoints, the cpu-thermal node is used. Also get the polling rate from
this node. Use the default of 5000ms if the polling rate should not be
specified in the devicetree.
NOTE: The polling rate from the devicetree will be used after this
patch. In imx8*.dtsi devicetrees the polling delay is set to 2000ms for
example.
Signed-off-by: Benjamin Hahn <b.h...@phytec.de>
---
drivers/thermal/imx_tmu.c | 6 ++++--
1 file changed, 4 insertions(+), 2 deletions(-)
diff --git a/drivers/thermal/imx_tmu.c b/drivers/thermal/imx_tmu.c
index 4721cfbc0218..c7fe0f07a607 100644
--- a/drivers/thermal/imx_tmu.c
+++ b/drivers/thermal/imx_tmu.c
@@ -570,12 +570,14 @@ static int imx_tmu_parse_fdt(struct udevice *dev)
{
struct imx_tmu_plat *pdata = dev_get_plat(dev), *p_parent_data;
struct ofnode_phandle_args args;
- ofnode trips_np;
+ ofnode trips_np, cpu_thermal_np;
int ret;
dev_dbg(dev, "%s\n", __func__);
- pdata->polling_delay = IMX_TMU_POLLING_DELAY_MS;
+ cpu_thermal_np = ofnode_path("/thermal-zones/cpu-thermal");
+ pdata->polling_delay = ofnode_read_u32_default(cpu_thermal_np,
"polling-delay",
+
IMX_TMU_POLLING_DELAY_MS);
if (pdata->zone_node) {
pdata->regs = (union tmu_regs *)dev_read_addr_ptr(dev);
---
base-commit: eac52e4be4e234d563d6911737ee7ccdc0ada1f1
change-id: 20240304-fix-thermal-driver-issue-34004526aa4f
Best regards,
--
Benjamin Hahn <b.h...@phytec.de>
