On Fri, 16 Feb 2024 at 02:22, Caleb Connolly <caleb.conno...@linaro.org> wrote:
>
> Some platforms hard reset when attempting to configure PMIC GPIOs. Add
> support for quirks specified in match data with a single quirk to skip
> this configuration. We rely on the GPIO already be configured correctly,
> which is always the case for volume up (the only current user of these
> GPIOs).
I can't find a similar quirk in the counterpart Linux driver
(drivers/pinctrl/qcom/pinctrl-spmi-gpio.c). Is there anything we are
missing in the U-Boot driver?
-Sumit
>
> Signed-off-by: Caleb Connolly <caleb.conno...@linaro.org>
> ---
> drivers/gpio/qcom_pmic_gpio.c | 18 ++++++++++++++++--
> 1 file changed, 16 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/gpio/qcom_pmic_gpio.c b/drivers/gpio/qcom_pmic_gpio.c
> index 2a4fef8d28cb..198cd84bc31e 100644
> --- a/drivers/gpio/qcom_pmic_gpio.c
> +++ b/drivers/gpio/qcom_pmic_gpio.c
> @@ -64,6 +64,15 @@
> #define REG_EN_CTL 0x46
> #define REG_EN_CTL_ENABLE (1 << 7)
>
> +/**
> + * pmic_gpio_match_data - platform specific configuration
> + *
> + * @PMIC_MATCH_READONLY: treat all GPIOs as readonly, don't attempt to
> configure them
> + */
> +enum pmic_gpio_quirks {
> + QCOM_PMIC_QUIRK_READONLY = (1 << 0),
> +};
> +
> struct qcom_gpio_bank {
> uint32_t pid; /* Peripheral ID on SPMI bus */
> bool lv_mv_type; /* If subtype is GPIO_LV(0x10) or GPIO_MV(0x11)
> */
> @@ -75,7 +84,12 @@ static int qcom_gpio_set_direction(struct udevice *dev,
> unsigned offset,
> struct qcom_gpio_bank *priv = dev_get_priv(dev);
> uint32_t gpio_base = priv->pid + REG_OFFSET(offset);
> uint32_t reg_ctl_val;
> - int ret;
> + ulong quirks = dev_get_driver_data(dev);
> + int ret = 0;
> +
> + /* Some PMICs don't like their GPIOs being configured */
> + if (quirks & QCOM_PMIC_QUIRK_READONLY)
> + return 0;
>
> /* Disable the GPIO */
> ret = pmic_clrsetbits(dev->parent, gpio_base + REG_EN_CTL,
> @@ -304,7 +318,7 @@ static int qcom_gpio_of_to_plat(struct udevice *dev)
> static const struct udevice_id qcom_gpio_ids[] = {
> { .compatible = "qcom,pm8916-gpio" },
> { .compatible = "qcom,pm8994-gpio" }, /* 22 GPIO's */
> - { .compatible = "qcom,pm8998-gpio" },
> + { .compatible = "qcom,pm8998-gpio", .data = QCOM_PMIC_QUIRK_READONLY
> },
> { .compatible = "qcom,pms405-gpio" },
> { }
> };
>
> --
> 2.43.1
>
