Hi Heinrich, thanks for your comments. I fixed all these issues in v4.
On 15.02.24 14:53, Heinrich Schuchardt wrote: > On 15.02.24 2:35 PM, Frieder Schrempf wrote: >> From: Frieder Schrempf <frieder.schre...@kontron.de> >> >> Describe how to build and boot for the Sielaff i.MX6 Solo board. >> >> Signed-off-by: Frieder Schrempf <frieder.schre...@kontron.de> >> --- >> Changes in v3: >> * include docs in upper-level index >> >> Changes in v2: >> * none >> --- >> doc/board/index.rst | 1 + >> doc/board/sielaff/imx6dl-sielaff.rst | 32 ++++++++++++++++++++++++++++ >> doc/board/sielaff/index.rst | 9 ++++++++ >> 3 files changed, 42 insertions(+) >> create mode 100644 doc/board/sielaff/imx6dl-sielaff.rst >> create mode 100644 doc/board/sielaff/index.rst >> >> diff --git a/doc/board/index.rst b/doc/board/index.rst >> index d0f9f355d2e..62357c99388 100644 >> --- a/doc/board/index.rst >> +++ b/doc/board/index.rst >> @@ -42,6 +42,7 @@ Board-specific doc >> renesas/index >> rockchip/index >> samsung/index >> + sielaff/index >> siemens/index >> sifive/index >> sipeed/index >> diff --git a/doc/board/sielaff/imx6dl-sielaff.rst >> b/doc/board/sielaff/imx6dl-sielaff.rst >> new file mode 100644 >> index 00000000000..24dd67ccaef >> --- /dev/null >> +++ b/doc/board/sielaff/imx6dl-sielaff.rst >> @@ -0,0 +1,32 @@ >> +.. SPDX-License-Identifier: GPL-2.0+ >> + >> +Sielaff i.MX6 Solo Board >> +======================== >> + >> +The Sielaff i.MX6 Solo board is a control and HMI board for vending >> +machines. > > Thank you for providing the build instruction. > > I had to look up the abbreviation: > > %s/HMI/Human Machine Interface (HMI)/ > >> + >> +Quick Start >> +----------- >> + >> +- Build U-Boot >> +- Boot > > These lines are not needed. We have a navigation tree on the left side > of the generated HTML page. > >> + >> +Build U-Boot >> +^^^^^^^^^^^^ >> + >> +.. code-block:: bash >> + >> + $ make imx6dl_sielaff_defconfig >> + $ make CROSS_COMPILE=arm-none-linux-gnueabihf- > > U-Boot does not use floats. > > make CROSS_COMPILE=arm-linux-gnueabi- > >> + >> +Burn the flash.bin to SD card at an offset of 1 KiB: > > Copy the flash.bin file to an SD card at an offset of 1 KiB: > >> + >> +.. code-block:: bash >> + >> + $ dd if=flash.bin of=/dev/sd[x] bs=1K seek=1 conv=notrunc > > Please, remove '$ '. It makes copy and paste more difficult. > Anyway $ is the wrong prompt. Only root can use dd. > If you really want a prompt, use: > > .. prompt:: bash # > > conv=notrunc has no effect on SD-cards but is needed when copying to an > image file. Thanks Frieder
