From: Fabio Estevam <feste...@denx.de>
With Ethernet DM in place, there is no longer the need for having
the board_phy_config() anymore.
Remove it.
Tested on imx7d-pico-pi board:
=> setenv autoload no
=> dhcp
BOOTP broadcast 1
*** Unhandled DHCP Option in OFFER/ACK: 42
DHCP client bound to address 192.168.0.138 (138 ms)
=> tftp zImage
Using ethernet@30be0000 device
TFTP from server 192.168.0.16; our IP address is 192.168.0.138
Filename 'zImage'.
Load address: 0x80800000
Loading: #################################################################
....
#################################################################
##########
4.3 MiB/s
done
Bytes transferred = 9034120 (89d988 hex)
Signed-off-by: Fabio Estevam <feste...@denx.de>
---
board/technexion/pico-imx7d/pico-imx7d.c | 26 ------------------------
1 file changed, 26 deletions(-)
diff --git a/board/technexion/pico-imx7d/pico-imx7d.c
b/board/technexion/pico-imx7d/pico-imx7d.c
index 6e98b85b2873..5def6eda43e5 100644
--- a/board/technexion/pico-imx7d/pico-imx7d.c
+++ b/board/technexion/pico-imx7d/pico-imx7d.c
@@ -101,32 +101,6 @@ static int setup_fec(void)
return set_clk_enet(ENET_125MHZ);
}
-
-int board_phy_config(struct phy_device *phydev)
-{
- unsigned short val;
-
- /* To enable AR8035 ouput a 125MHz clk from CLK_25M */
- phy_write(phydev, MDIO_DEVAD_NONE, 0xd, 0x7);
- phy_write(phydev, MDIO_DEVAD_NONE, 0xe, 0x8016);
- phy_write(phydev, MDIO_DEVAD_NONE, 0xd, 0x4007);
-
- val = phy_read(phydev, MDIO_DEVAD_NONE, 0xe);
- val &= 0xffe7;
- val |= 0x18;
- phy_write(phydev, MDIO_DEVAD_NONE, 0xe, val);
-
- /* introduce tx clock delay */
- phy_write(phydev, MDIO_DEVAD_NONE, 0x1d, 0x5);
- val = phy_read(phydev, MDIO_DEVAD_NONE, 0x1e);
- val |= 0x0100;
- phy_write(phydev, MDIO_DEVAD_NONE, 0x1e, val);
-
- if (phydev->drv->config)
- phydev->drv->config(phydev);
-
- return 0;
-}
#endif
static void setup_iomux_uart(void)
--
2.34.1
