> The i.MX93 11x11 EVK fails to boot with following error:
> Model: NXP i.MX93 11X11 EVK board
> DRAM: 2 GiB
> Error binding driver 'imx93-adc': -96
> Some drivers failed to bind
> Error binding driver 'simple_bus': -96
> Some drivers failed to bind
> Error binding driver 'simple_bus': -96
> Some drivers failed to bind
> initcall sequence 00000000fffb8f28 failed at call 000000008021e0d4 (err=-96)
> ### ERROR ### Please RESET the board ###
> That's because since commit e7ff54d96303 ("imx93_evk: defconfig: add adc
> support") CONFIG_ADC_IMX93 is enabled but CONFIG_ADC is not.
> Fix this by enabling CONFIG_ADC in imx93_11x11_evk_defconfig.
> Make sure this situation won't happen again in future i.MX93 defconfig by
> making CONFIG_ADC_IMX93 depend on CONFIG_ADC.
> Signed-off-by: Sébastien Szymanski <sebastien.szyman...@armadeus.com>
> Reviewed-by: Fabio Estevam <feste...@gmail.com>
Applied to u-boot-imx, master, thanks !
Best regards,
Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, Managing Director: Erika Unter
HRB 165235 Munich, Office: Kirchenstr.5, 82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
=====================================================================
