> From: Andrejs Cainikovs <andrejs.cainik...@toradex.com> > Drive CTRL_SLEEP_MOCI# high at boot (SPL) using a GPIO hog, this signal > may be used to control some power-rails on the carrier board, therefore > it should be set to high when the module is booting. > To do this as early as possible is generally a good idea and the issue > was noticed on the Yavia carrier board where it is needed to power the > I2C EEPROM on the carrier board. > Signed-off-by: Andrejs Cainikovs <andrejs.cainik...@toradex.com> > Signed-off-by: Marcel Ziswiler <marcel.ziswi...@toradex.com> Applied to u-boot-imx, master, thanks !
Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Erika Unter HRB 165235 Munich, Office: Kirchenstr.5, 82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de =====================================================================
