Hi Tom,
On Wed, May 3, 2023 at 4:01 PM Tom Rini <tr...@konsulko.com> wrote:
> So, both my HW test and CI is fine, so I've applied this. But please
> note we now have this scary message to fix:
> +(imx8qm_dmsse20a1) aarch64-linux-ld.bfd: invalid origin for memory region
> .sdram
I compared the imx8qm_dmsse20a1 against imx8qm_mek_defconfig and with
the following changes the warning is gone:
--- a/configs/imx8qm_dmsse20a1_defconfig
+++ b/configs/imx8qm_dmsse20a1_defconfig
@@ -16,6 +16,7 @@ CONFIG_SPL_SERIAL=y
CONFIG_SPL_DRIVERS_MISC=y
CONFIG_ENV_OFFSET=0x80000
CONFIG_ENV_SECT_SIZE=0x20000
+CONFIG_SPL_STACK=0x13e000
CONFIG_SPL=y
CONFIG_SYS_LOAD_ADDR=0x80280000
CONFIG_SYS_MEMTEST_START=0xA0000000
@@ -38,11 +39,17 @@ CONFIG_USE_BOOTCOMMAND=y
CONFIG_BOOTCOMMAND="mmc dev ${mmcdev}; if mmc rescan; then if run
loadbootscript; then run bootscript; else if run loadimage; then run
mmcboot; else run netboot; fi; fi; else booti ${loadaddr} -
${fdt_addr}; fi"
CONFIG_LOG=y
CONFIG_BOARD_EARLY_INIT_F=y
-CONFIG_SPL_BSS_START_ADDR=0x00128000
CONFIG_SPL_MAX_SIZE=0x1f000
+CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
+CONFIG_SPL_BSS_START_ADDR=0x128000
CONFIG_SPL_BSS_MAX_SIZE=0x1000
CONFIG_SPL_BOARD_INIT=y
-CONFIG_SPL_SEPARATE_BSS=y
+CONFIG_SPL_SYS_MALLOC_SIMPLE=y
+# CONFIG_SPL_SHARES_INIT_SP_ADDR is not set
+CONFIG_SYS_SPL_MALLOC=y
+CONFIG_HAS_CUSTOM_SPL_MALLOC_START=y
+CONFIG_CUSTOM_SYS_SPL_MALLOC_ADDR=0x120000
+CONFIG_SYS_SPL_MALLOC_SIZE=0x3000
CONFIG_SPL_POWER_SUPPORT=y
CONFIG_SPL_POWER_DOMAIN=y
CONFIG_SPL_WATCHDOG_SUPPORT=y
Oliver, could you please test this change?
I can submit it formally if it works for you.
