Hi Tom,
On Fri, 2011-01-21 at 16:06 -0700, Tom Warren wrote:
> Signed-off-by: Tom Warren <twar...@nvidia.com>
> ---
> Changes for V2:
> - Move serial driver to separate patch
>
> Changes for V5:
> - Move arch/arm/cpu/armv7/uart.c & board.h to drivers/serial and
> rename to serial_tegra2.c
> - Remove use of uart_num & UART_A/D in serial_tegra2, simplify code
>
> arch/arm/cpu/armv7/tegra2/Makefile | 2 +-
> arch/arm/cpu/armv7/tegra2/board.c | 2 +-
> arch/arm/cpu/armv7/tegra2/board.h | 58 ----------
> arch/arm/cpu/armv7/tegra2/uart.c | 216
> ------------------------------------
> common/serial.c | 3 +-
> drivers/serial/Makefile | 1 +
> drivers/serial/serial_tegra2.c | 205 ++++++++++++++++++++++++++++++++++
> drivers/serial/serial_tegra2.h | 49 ++++++++
> include/serial.h | 3 +-
> 9 files changed, 261 insertions(+), 278 deletions(-)
> delete mode 100644 arch/arm/cpu/armv7/tegra2/board.h
> delete mode 100644 arch/arm/cpu/armv7/tegra2/uart.c
> create mode 100644 drivers/serial/serial_tegra2.c
> create mode 100644 drivers/serial/serial_tegra2.h
It looks like arch/arm/cpu/armv7/tegra2/board.h and
arch/arm/cpu/armv7/tegra2/uart.c are added in the first patch, then
moved in this patch. It'd be ideal to just add them once in the proper
location.
On a side note, if you pass "git format-patch" the -M and -C options it
will make pretty diffs that only show what lines changed during a move.
In the case that you do move files in the future its nice to use those
options to ease review.
<snip>
+void uart_init(void)
> +{
> + /* Init each UART - there may be more than 1 on a board/build */
> +#if (CONFIG_TEGRA2_ENABLE_UARTA)
> + init_uart();
> +#endif
> +#if (CONFIG_TEGRA2_ENABLE_UARTD)
> + init_uart();
> +#endif
> +}
How about:
#if defined(CONFIG_TEGRA2_ENABLE_UARTA) || defined(CONFIG_TEGRA2_ENABLE_UARTD)
init_uart();
#endif
Best,
Peter
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
