On Jan 14, 2011, at 10:41 AM, Kumar Gala wrote: > From: Poonam Aggrwal <poonam.aggr...@freescale.com> > > Key Features include of the P1010: > * e500v2 core frequency operation of 500 to 800 MHz > * Power consumption less than 5.0 W at 800 MHz core speed > * Dual SATA 3 Gbps controllers with integrated PHY > * Dual PCI Express controllers > * Three 10/100/1000 Mbps enhanced triple-speed Ethernet controllers (eTSECs) > * TCP/IP acceleration and classification capabilities > * IEEE 1588 support > * Lossless flow control > * RGMII, SGMII > * DDR3 with support for a 32-bit data interface (40 bits including ECC), > up to 800 MHz data rate 32/16-bit DDR3 memory controller > * Dedicated security engine featuring trusted boot > * TDM interface > * Dual controller area networks (FlexCAN) controller > * SD/MMC card controller supporting booting from Flash cards > * USB 2.0 host and device controller with an on-chip, high-speed PHY > * Integrated Flash controller (IFC) > * Power Management Controller (PMC) > * Four-channel, general-purpose DMA controller > * I2C controller > * Serial peripheral interface (SPI) controller with master and slave support > * System timers including a periodic interrupt timer, real-time clock, > software watchdog timer, and four general-purpose timers > * Dual DUARTs > > Signed-off-by: Poonam Aggrwal <poonam.aggr...@freescale.com> > Signed-off-by: Dipen Dudhat <dipen.dud...@freescale.com> > Signed-off-by: Kumar Gala <ga...@kernel.crashing.org> > --- > arch/powerpc/cpu/mpc85xx/Makefile | 1 + > arch/powerpc/cpu/mpc8xxx/cpu.c | 2 ++ > arch/powerpc/include/asm/config.h | 6 ++++-- > arch/powerpc/include/asm/processor.h | 2 ++ > drivers/misc/fsl_law.c | 1 + > 5 files changed, 10 insertions(+), 2 deletions(-)
applied to 85xx - k _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
