Dear Macpaul Lin, In message <1292921986-23419-1-git-send-email-macp...@andestech.com> you wrote: > Add Faraday's ftgmac100 (gigabit ethernet) > MAC controller's driver. > > Signed-off-by: Macpaul Lin <macp...@andestech.com> > --- > Changes for v2: > - Coding Style cleanup > - Makefile Order sorted > - Volatile statement eliminated > - Error handling added > - Autonegotiation timeout value rechecked > - Link speed detection code is reduced > - Logic of autonegotiation and Link speed update reorganized > - Redundent registers offset table cleared > - The explaination of sub configuration of this > driver has moved into README > > Changes for v3: > - Coding Style clean up about > - 2 continue blank line > - incorrect multi-line comment style > - useless else statement and return value statement > - make multi-line statement into single line which doesn't exceed 80 chars > - brance with multi-line statement (comments included before one line > code) > > README | 12 + > drivers/net/Makefile | 1 + > drivers/net/ftgmac100.c | 570 > +++++++++++++++++++++++++++++++++++++++++++++++ > drivers/net/ftgmac100.h | 255 +++++++++++++++++++++ > include/netdev.h | 1 + > 5 files changed, 839 insertions(+), 0 deletions(-) > create mode 100644 drivers/net/ftgmac100.c > create mode 100644 drivers/net/ftgmac100.h
Applied, thanks. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de Madness takes its toll. Please have exact change. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
