Instead of using DEBUG or LOG_DEBUG the driver still had its own definition for debug output.
Signed-off-by: Alexander Dahl <a...@thorsis.com> --- drivers/fpga/virtex2.c | 37 +++++++++++++++---------------------- 1 file changed, 15 insertions(+), 22 deletions(-) diff --git a/drivers/fpga/virtex2.c b/drivers/fpga/virtex2.c index 51b8d31205..fddf8ac4ce 100644 --- a/drivers/fpga/virtex2.c +++ b/drivers/fpga/virtex2.c @@ -12,21 +12,14 @@ * on spartan2.c (Rich Ireland, rirel...@enterasys.com). */ +#define LOG_CATEGORY UCLASS_FPGA + #include <common.h> #include <console.h> +#include <log.h> #include <virtex2.h> #include <linux/delay.h> -#if 0 -#define FPGA_DEBUG -#endif - -#ifdef FPGA_DEBUG -#define PRINTF(fmt, args...) printf(fmt, ##args) -#else -#define PRINTF(fmt, args...) -#endif - /* * If the SelectMap interface can be overrun by the processor, define * CONFIG_SYS_FPGA_CHECK_BUSY and/or CONFIG_FPGA_DELAY in the board @@ -89,12 +82,12 @@ static int virtex2_load(xilinx_desc *desc, const void *buf, size_t bsize, switch (desc->iface) { case slave_serial: - PRINTF("%s: Launching Slave Serial Load\n", __func__); + log_debug("%s: Launching Slave Serial Load\n", __func__); ret_val = virtex2_ss_load(desc, buf, bsize); break; case slave_selectmap: - PRINTF("%s: Launching Slave Parallel Load\n", __func__); + log_debug("%s: Launching Slave Parallel Load\n", __func__); ret_val = virtex2_ssm_load(desc, buf, bsize); break; @@ -111,12 +104,12 @@ static int virtex2_dump(xilinx_desc *desc, const void *buf, size_t bsize) switch (desc->iface) { case slave_serial: - PRINTF("%s: Launching Slave Serial Dump\n", __func__); + log_debug("%s: Launching Slave Serial Dump\n", __func__); ret_val = virtex2_ss_dump(desc, buf, bsize); break; case slave_parallel: - PRINTF("%s: Launching Slave Parallel Dump\n", __func__); + log_debug("%s: Launching Slave Parallel Dump\n", __func__); ret_val = virtex2_ssm_dump(desc, buf, bsize); break; @@ -150,8 +143,8 @@ static int virtex2_slave_pre(xilinx_virtex2_slave_fns *fn, int cookie) { unsigned long ts; - PRINTF("%s:%d: Start with interface functions @ 0x%p\n", - __func__, __LINE__, fn); + log_debug("%s:%d: Start with interface functions @ 0x%p\n", + __func__, __LINE__, fn); if (!fn) { printf("%s:%d: NULL Interface function table!\n", @@ -160,7 +153,7 @@ static int virtex2_slave_pre(xilinx_virtex2_slave_fns *fn, int cookie) } /* Gotta split this one up (so the stack won't blow??) */ - PRINTF("%s:%d: Function Table:\n" + log_debug("%s:%d: Function Table:\n" " base 0x%p\n" " struct 0x%p\n" " pre 0x%p\n" @@ -169,7 +162,7 @@ static int virtex2_slave_pre(xilinx_virtex2_slave_fns *fn, int cookie) " error 0x%p\n", __func__, __LINE__, &fn, fn, fn->pre, fn->pgm, fn->init, fn->err); - PRINTF(" clock 0x%p\n" + log_debug(" clock 0x%p\n" " cs 0x%p\n" " write 0x%p\n" " rdata 0x%p\n" @@ -330,8 +323,8 @@ static int virtex2_ssm_load(xilinx_desc *desc, const void *buf, size_t bsize) #endif if ((*fn->done)(cookie) == FPGA_SUCCESS) { - PRINTF("%s:%d:done went active early, bytecount = %d\n", - __func__, __LINE__, bytecount); + log_debug("%s:%d:done went active early, bytecount = %d\n", + __func__, __LINE__, bytecount); break; } @@ -465,8 +458,8 @@ static int virtex2_ss_load(xilinx_desc *desc, const void *buf, size_t bsize) #endif if ((*fn->done)(cookie) == FPGA_SUCCESS) { - PRINTF("%s:%d:done went active early, bytecount = %d\n", - __func__, __LINE__, bytecount); + log_debug("%s:%d:done went active early, bytecount = %d\n", + __func__, __LINE__, bytecount); break; } -- 2.30.2