Instead of using DEBUG or LOG_DEBUG the driver still had its own definition for debug output.
Signed-off-by: Alexander Dahl <a...@thorsis.com> --- drivers/fpga/cyclon2.c | 24 ++++++++++-------------- 1 file changed, 10 insertions(+), 14 deletions(-) diff --git a/drivers/fpga/cyclon2.c b/drivers/fpga/cyclon2.c index 3b008facb8..002fa2ca5d 100644 --- a/drivers/fpga/cyclon2.c +++ b/drivers/fpga/cyclon2.c @@ -5,18 +5,14 @@ * Based on ACE1XK.c */ +#define LOG_CATEGORY UCLASS_FS_FIRMWARE_LOADER + #include <common.h> /* core U-Boot definitions */ +#include <log.h> #include <altera.h> #include <ACEX1K.h> /* ACEX device family */ #include <linux/delay.h> -/* Define FPGA_DEBUG to get debug printf's */ -#ifdef FPGA_DEBUG -#define PRINTF(fmt, args...) printf(fmt, ##args) -#else -#define PRINTF(fmt, args...) -#endif - /* Note: The assumption is that we cannot possibly run fast enough to * overrun the device (the Slave Parallel mode can free run at 50MHz). * If there is a need to operate slower, define CONFIG_FPGA_DELAY in @@ -42,7 +38,7 @@ int CYC2_load(Altera_desc *desc, const void *buf, size_t bsize) switch (desc->iface) { case passive_serial: - PRINTF("%s: Launching Passive Serial Loader\n", __func__); + log_debug("%s: Launching Passive Serial Loader\n", __func__); ret_val = CYC2_ps_load(desc, buf, bsize); break; @@ -51,8 +47,8 @@ int CYC2_load(Altera_desc *desc, const void *buf, size_t bsize) * done in the write() callback. Use the existing PS load * function for FPP, too. */ - PRINTF("%s: Launching Fast Passive Parallel Loader\n", - __func__); + log_debug("%s: Launching Fast Passive Parallel Loader\n", + __func__); ret_val = CYC2_ps_load(desc, buf, bsize); break; @@ -72,7 +68,7 @@ int CYC2_dump(Altera_desc *desc, const void *buf, size_t bsize) switch (desc->iface) { case passive_serial: - PRINTF("%s: Launching Passive Serial Dump\n", __func__); + log_debug("%s: Launching Passive Serial Dump\n", __func__); ret_val = CYC2_ps_dump(desc, buf, bsize); break; @@ -99,14 +95,14 @@ static int CYC2_ps_load(Altera_desc *desc, const void *buf, size_t bsize) Altera_CYC2_Passive_Serial_fns *fn = desc->iface_fns; int ret = 0; - PRINTF("%s: start with interface functions @ 0x%p\n", - __func__, fn); + log_debug("%s: start with interface functions @ 0x%p\n", + __func__, fn); if (fn) { int cookie = desc->cookie; /* make a local copy */ unsigned long ts; /* timestamp */ - PRINTF("%s: Function Table:\n" + log_debug("%s: Function Table:\n" "ptr:\t0x%p\n" "struct: 0x%p\n" "config:\t0x%p\n" -- 2.30.2