Rather than keep the load_addr definition with the bootm code (which
just happens to use this), move it to the common env code. This way
we can disable bootm support completely while retaining load_addr
usage with many other commands.
Signed-off-by: Mike Frysinger <vap...@gentoo.org>
---
common/cmd_bootm.c | 1 -
common/cmd_nvedit.c | 2 ++
2 files changed, 2 insertions(+), 1 deletions(-)
diff --git a/common/cmd_bootm.c b/common/cmd_bootm.c
index 1a024f1..b7f96c2 100644
--- a/common/cmd_bootm.c
+++ b/common/cmd_bootm.c
@@ -157,7 +157,6 @@ static boot_os_fn *boot_os[] = {
#endif
};
-ulong load_addr = CONFIG_SYS_LOAD_ADDR; /* Default Load Address */
static bootm_headers_t images; /* pointers to os/initrd/fdt images */
/* Allow for arch specific config before we boot */
diff --git a/common/cmd_nvedit.c b/common/cmd_nvedit.c
index dcc93c1..e9d3d1b 100644
--- a/common/cmd_nvedit.c
+++ b/common/cmd_nvedit.c
@@ -76,6 +76,8 @@ SPI_FLASH|MG_DISK|NVRAM|MMC|NOWHERE}
*/
#define MAX_ENV_SIZE (1 << 20) /* 1 MiB */
+ulong load_addr = CONFIG_SYS_LOAD_ADDR; /* Default Load Address */
+
/*
* Table with supported baudrates (defined in config_xyz.h)
*/
--
1.7.3.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
