On Mon,  9 May 2022 00:10:55 -0500
Samuel Holland <sam...@sholland.org> wrote:

> These were only ever implied by sunxi platforms, and that usage has
> been removed. Current practice is to specify CONFIG_CONS_INDEX in each
> board's defconfig.
> 
> Signed-off-by: Samuel Holland <sam...@sholland.org>

Applied to sunxi/master.

Thanks!
Andre

> ---
> 
>  drivers/serial/Kconfig | 26 --------------------------
>  1 file changed, 26 deletions(-)
> 
> diff --git a/drivers/serial/Kconfig b/drivers/serial/Kconfig
> index 1e595d0600..71a0591697 100644
> --- a/drivers/serial/Kconfig
> +++ b/drivers/serial/Kconfig
> @@ -74,36 +74,10 @@ config TPL_SERIAL_PRESENT
>         This option enables the full UART in TPL, so if is it disabled,
>         the full UART driver will be omitted, thus saving space.
>  
> -# Logic to allow us to use the imply keyword to set what the default port
> -# should be.  The default is otherwise 1.
> -config CONS_INDEX_0
> -     bool
> -
> -config CONS_INDEX_2
> -     bool
> -
> -config CONS_INDEX_3
> -     bool
> -
> -config CONS_INDEX_4
> -     bool
> -
> -config CONS_INDEX_5
> -     bool
> -
> -config CONS_INDEX_6
> -     bool
> -
>  config CONS_INDEX
>       int "UART used for console"
>       depends on SPECIFY_CONSOLE_INDEX
>       range 0 6
> -     default 0 if CONS_INDEX_0
> -     default 2 if CONS_INDEX_2
> -     default 3 if CONS_INDEX_3
> -     default 4 if CONS_INDEX_4
> -     default 5 if CONS_INDEX_5
> -     default 6 if CONS_INDEX_6
>       default 1
>       help
>         Set this to match the UART number of the serial console.

Reply via email to