On 06.05.22 11:05, Pali Rohár wrote:
SPL_DEBUG_UART_BASE is same as DEBUG_UART_BASE, but applies only for SPL.
In some cases base address of UART is different in SPL and proper U-Boot.
Signed-off-by: Pali Rohár <p...@kernel.org>
Reviewed-by: Stefan Roese <s...@denx.de>
Thanks,
Stefan
---
drivers/serial/Kconfig | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/drivers/serial/Kconfig b/drivers/serial/Kconfig
index 26fa498bbbb7..46726d76b162 100644
--- a/drivers/serial/Kconfig
+++ b/drivers/serial/Kconfig
@@ -508,6 +508,13 @@ config DEBUG_UART_BASE
A default should be provided by your board, but if not you will need
to use the correct value here.
+config SPL_DEBUG_UART_BASE
+ hex "Base address of UART for SPL"
+ depends on SPL && DEBUG_UART
+ default DEBUG_UART_BASE
+ help
+ This is the base address of your UART for memory-mapped UARTs for SPL.
+
config DEBUG_UART_CLOCK
int "UART input clock"
depends on DEBUG_UART
Viele Grüße,
Stefan Roese
--
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-51 Fax: (+49)-8142-66989-80 Email: s...@denx.de
