[PATCH 5/9] arm: dts: k3-j721e-common-proc-board: enable hyperflash mux sel GPIO

[Vaishnav Achath]

Add wkup_gpio pinmux setting which will be used for performing the
DT fixup for hbmc node according to mux selection state, on J721E
EVM, hypermux sel is tied to ·WKUP_GPIO0_8.

Signed-off-by: Vaishnav Achath <vaishna...@ti.com>
---
 arch/arm/dts/k3-j721e-common-proc-board.dts | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/arch/arm/dts/k3-j721e-common-proc-board.dts 
b/arch/arm/dts/k3-j721e-common-proc-board.dts
index f3b6302a43..1b600547c0 100644
--- a/arch/arm/dts/k3-j721e-common-proc-board.dts
+++ b/arch/arm/dts/k3-j721e-common-proc-board.dts
@@ -213,6 +213,12 @@
                >;
        };
 
+       wkup_gpio_pins_default: wkup-gpio-pins-default {
+               pinctrl-single,pins = <
+                       J721E_WKUP_IOPAD(0xd0, PIN_INPUT, 7) /* (C14) 
WKUP_GPIO0_8 */
+               >;
+       };
+
        mcu_fss0_ospi1_pins_default: mcu-fss0-ospi1-pins-default {
                pinctrl-single,pins = <
                        J721E_WKUP_IOPAD(0x34, PIN_OUTPUT, 0) /* (F22) 
MCU_OSPI1_CLK */
@@ -381,6 +387,11 @@
        phy-names = "cdns3,usb3-phy";
 };
 
+&wkup_gpio0 {
+       pinctrl-names = "default";
+       pinctrl-0 = <&wkup_gpio_pins_default>;
+};
+
 &usbss1 {
        pinctrl-names = "default";
        pinctrl-0 = <&main_usbss1_pins_default>;
-- 
2.17.1