On 5/5/22 7:37 PM, Andre Przywara wrote:
> When CONFIG_UART0_PORT_F is defined, we try to configure two PortF pins
> (usually used for the SD card) as UART0. Some SoCs use the mux value of
> 3 for this, while others use 4.
> 
> The combination of Kconfig symbols we currently use was not quite right:
> we mis-configure the A31, A64, H6 and H616.
> 
> Going through the list in the pinctrl driver, there are only a few older
> SoCs that use a value of 4, so revert the #ifdef clause, and name those
> explicitly, instead of the other way around.
> 
> Signed-off-by: Andre Przywara <andre.przyw...@arm.com>

Reviewed-by: Samuel Holland <sam...@sholland.org>

Reply via email to