>-----Original Message----- >From: U-Boot <[email protected]> On Behalf Of Pali Rohár >Sent: Tuesday, April 5, 2022 6:43 PM >To: Priyanka Jain <[email protected]>; Qiang Zhao <[email protected]>; >Shengzhou Liu <[email protected]>; Alexander Graf <[email protected]>; >Bin Meng <[email protected]>; Wolfgang Denk <[email protected]>; Sinan >Akman <[email protected]> >Cc: [email protected] >Subject: [PATCH 7/8] powerpc: mpc85xx: Set TEXT_BASE addresses to real base >values > >Currently CONFIG_SPL_TEXT_BASE and CONFIG_SYS_TEXT_BASE addresses are >manually increased by 0x1000 due to .bootpg section. This section has size of >0x1000 bytes and is manually put by linker script before .text section (and >therefore before base address) when CONFIG_SYS_MPC85XX_NO_RESETVEC is >set. Due to this fact lot of other config options are manually increased by >0x1000 value to make correct layout. Note that entry point is not on >CONFIG_SPL_TEXT_BASE (image+0x1000) but it is really on address >CONFIG_SPL_TEXT_BASE-0x1000 (means at the start of the image). > >Cleanup handling of .bootpg section when >CONFIG_SYS_MPC85XX_NO_RESETVEC is set. Put .bootpg code directly into .text >section and move text base address to the start of .bootpg code. And finally >remove +0x1000 value from lot of config options. With this removal custom >PHDRS is not used anymore, so remove it too. > >After this change entry point would be at CONFIG_SPL_TEXT_BASE and not at >address -0x1000 anymore. > >Tested on P2020 board with SPL and proper U-Boot. > >Signed-off-by: Pali Rohár <[email protected]> >---
Kindly rebase to top of tree. There has been changed related configs. I am picking patches till 6/8. So just send next version of 7/8 and 8/8 Regards Priyanka
