Hi
On 2022-01-17 06:11, Angus Ainslie wrote:
When CONFIG_DM_USB is not defined then usb_gadget_initialize is just a
call
to board_usb_init. Calling board_usb_init twice causes the USB to fail
so
make sure the second invocation is not compiled in when CONFIG_DM_USB
is
not defined.
Signed-off-by: Angus Ainslie <an...@akkea.ca>
---
common/spl/spl_sdp.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/common/spl/spl_sdp.c b/common/spl/spl_sdp.c
index ae9c09883a..2a2bc8475d 100644
--- a/common/spl/spl_sdp.c
+++ b/common/spl/spl_sdp.c
@@ -17,7 +17,8 @@ static int spl_sdp_load_image(struct spl_image_info
*spl_image,
int ret;
const int controller_index = CONFIG_SPL_SDP_USB_DEV;
- usb_gadget_initialize(controller_index);
+ if (IS_ENABLED(CONFIG_DM_USB))
+ usb_gadget_initialize(controller_index);
board_usb_init(0, USB_INIT_DEVICE);
Any comments on this patch ?
Thanks
Angus
