On Thu, Mar 31, 2022 at 8:43 AM Ramon Fried <rfried....@gmail.com> wrote:
>
> On Tue, Mar 29, 2022 at 11:28 PM Laurent Pinchart
> <laurent.pinch...@ideasonboard.com> wrote:
> >
> > Hello,
> >
> > I've banged my head a few days ago trying to debug an issue with a TFTP
> > transfer hanging in the middle.
> >
> > I'm testing U-Boot 2022-rc5 on a Toradex Verdin i.MX8MP module (using
> > the verdin-imx8mp defconfig). My local network MTU is 1500 bytes, and
> > the board uses the EQoS ethernet controller.
> >
> > The problem started occurring after rebuilding a kernel image. U-Boot
> > started transferring the image, and stopped in the middle, eventually
> > timing out. Capture network traffic showed that U-Boot was continuously
> > asking for retransmit of the same block, and eventually timed out.
> >
> > U-Boot is configured with a default TFTP block size of 4096 bytes, which
> > results in the TFTP blocks being sent in one UDP packet split in three
> > IP packets. U-Boot is configured with IP fragmentation supprot enabled.
> > This works fine for all TFTP blocks until a paticular one in the middle
> > of the kernel image.
> >
> > I've narrowed it down to a file of 1472 that can't be transferred at
> > all (I have attached the binary to this e-mail). Changing the value of
> > any of the last two bytes of the file allows transferring it correctly,
> > so I suspect a CRC issue, likely related to IP fragmentation. Lowering
> > the TFTP block size to avoid fragmentation works around the problem.
> >
> > Arguably a TFTP block size of 4096 bytes should probably not be used
> > with a 1500 bytes MTU network, but I thought it would be useful to fix
> > the issue nonetheless.
> >
> > I can test patches.
> >
> > --
> > Regards,
> >
> > Laurent Pinchart
> Interesting.
> I will try to reproduce.
> Thanks for reporting.
Hi.
I couldn't reproduce the issue with the file you provided.
I used sandbox64, and changed the TFTP BLOCK size to 4096.
I managed to TFTP the file successfully.
=> setenv autoload no
=> setenv ethrotate no
=> setenv ethact eth0
=> setenv ipaddr
=> setenv serverip 172.23.1.137
=> env set ipaddr 172.23.1.100
=> tftpboot 0x100000 test.bin
Using host_eno1 device
TFTP from server 172.23.1.137; our IP address is 172.23.1.100
Filename 'test.bin'.
Load address: 0x100000
Loading: #
718.8 KiB/s
done
Bytes transferred = 1472 (5c0 hex)
=>
Can you perhaps send me a network PCAP of your device failing to
digest the file ?
Thanks,
Ramon
