> > The patch adds basic board support for TI's OMAP-L138 based > Hawkboard. This board is pretty similar to the da850 EVM. Support for > nand and network access is added in this version. > > The following bootup procedure is used. > > At reset, the Rom Boot Loader(RBL), initialises the ddr and the nand > controllers and copies the second stage bootloader(nand_spl) to > RAM. The secondary bootloader then copies u-boot from a predefined > location in the nand flash to the RAM, and passes control to the > u-boot image. > > Three config options are supported > * hawkboard_config - Used to create the u-boot.bin. Tftp the > u-boot.bin image to the RAM from u-boot, and flash to the nand flash > at address 0xe0000. > > * hawkboard_nand_config - Used to generate the secondary > bootloader(nand_spl) image. This creates an elf file u-boot-spl > under nand_spl/. Create an AIS signed image using this file, and > flash it to the nand flash at address 0x20000. The ais file should > fit in one block. > > * hawkboard_uart_config - This is same as the first image, but with > the TEXT_BASE as expected by the RBL(0xc1080000). Create the AIS > > Signed-off-by: Sughosh Ganu <urwithsugh...@gmail.com> > Signed-off-by: Ben Gardiner <bengardi...@nanometrics.ca>
Pushed to u-boot-ti/next http://git.denx.de/?p=u-boot/u-boot-ti.git;a=commitdiff;h=48571ff00526701c88cfcac1294adf20aeeade74 Regards, Sandeep _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
